Abstract:The deposition of nanoscaled structures with a desired shape on the intended position of the substrate material is crucial for nanomaterial applications. Electron beam-induced deposition with a highly focused beam enables achievement of high accuracy and precision in this respect. Hence, we investigated the focused-electron-beam-induced deposition of Ru-containing deposits on SiO2 and sputter-cleaned silicon in ultrahigh vacuum to achieve comparably clean and morphologically well-defined Ru nanomaterials, which is relevant especially in the field of mask repair for extreme ultraviolet lithography. The precursor Ru(CO)4I2 was held at 340–345 K, and the applied electron doses were varied from 1.56 to 9.36 C/cm2 using a focused electron beam (5 keV, 1.5 nA, and 10 nm diameter). Local Auger electron spectroscopy along with subsequent sophisticated fitting procedures not only revealed the elemental composition but also enabled determination of the thickness of the fabricated deposits. Ru contents of up to 56% can be achieved at lower electron doses; at higher doses, the Ru content decreases to 45% and simultaneously the content increases. The initially lower I content is attributed to simultaneous focused electron beam-induced etching, which is found to be competing with the deposition process. The etching is evidenced by atomic force microscopy, where the structures are observed to have negative apparent height for low electron doses. With increasing electron doses, the deposits exhibit positive apparent heights because the etching is less pronounced at higher electron doses, once the Ru surface coverage has increased. The high Ru content and difficult balance between electron-induced deposition and etching considerably expand the possibilities of engineering nanostructured materials.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsanm.1c04481.AES on a Ru crystal before and after sputtering (Figure S1), AES on a clean Ru crystal with E × N(E) versus E and dN/dE versus E signal types (Figure S2), AES on clean Ag and Ru substrates with E × N(E) versus E and dN/dE versus E signal types (Figure S3), AES on the SiO2 substrate before and after sputtering (Figure S4), AES intensities of the SiMNN peak (1615 eV) under different electron doses (Figure S5), AES damping SiMNN signal for clean Si and 5 and 3 keV FEBID structures (Figure S6), calculations for the precursor flux and current density (Section S1), and calculations for the attenuation length, thickness estimation, and information depth (Section S2) (PDF)This article has not yet been cited by other publications.

Ultrafast Time-Resolved Pump–Probe Investigation of Nanosecond Extreme Ultraviolet-Light-Induced Damage Dynamics on B 4 C/Ru Nano-Bilayer Film

Laser-induced electron dynamics and surface modification in ruthenium thin films

Residual Stress Inspection by Eu3+ Photoluminescence Piezo-Spectroscopy: an Application in Thermal Barrier Coatings

Imaging and Controlling Ultrafast Electron Pulses Emitted from Plasmonic Nanostructures

Non-contact XUV metrology of Ru/B4C multilayer optics by means of Hartmann wavefront analysis

Ultrafast Process Characterization of Laser-Induced Damage in Fused Silica Using Pump-Probe Shadow Imaging Techniques

Ultrafast Laser Material Damage Simulation—A New Look at an Old Problem

Direct Testing against Experiment of a Fundamental Ultrashort Pulse Laser Damage Simulation Technique with Utility for the Modeling of Nanostructure Formation

Direct evidences for inner-shell electron-excitation by laser induced electron recollision

Laser-based apparatus for extended ultraviolet femtosecond time-resolved photoemission spectroscopy

Nanosecond UV laser induced subsurface damage mechanics of cemented tungsten carbide

Investigation on Thermal Barrier Coating Damages for Ultrafast Laser Drilling of Cooling Holes

Ultrafast Electron Diffraction at Surfaces:From Nanoscale Heat Transport to Driven Phase Transitions

Materials Properties and Solvated Electron Dynamics of Isolated Nanoparticles and Nanodroplets Probed with Ultrafast Extreme Ultraviolet Beams

Material-specific high-resolution table-top extreme ultraviolet microscopy

Ultrafast dynamics observation during femtosecond laser-material interaction

Temporal-Spatial Measurement of Surface Morphological Evolution Time in Nanosecond Laser Irradiation on the Copper Film

Ultrafast Adsorbate Excitation Probed with Subpicosecond-Resolution X-Ray Absorption Spectroscopy

Ultrafast dynamics in ZnO thin films irradiated by femtosecond lasers

Time-resolved Studies of Laser Damage Processes in DKDP Crystals

Nanoscale Ruthenium-Containing Deposits from Ru(CO) 4 I 2 via Simultaneous Focused Electron Beam-Induced Deposition and Etching in Ultrahigh Vacuum: Mask Repair in Extreme Ultraviolet Lithography and Beyond