Abstract:<div><div>Electric vehicles (EV’s) present new challenges to achieving the required noise, vibration & harshness performance (NVH) compared with conventional vehicles. Specifically, high-frequency noise and unexpected noise phenomenon, previously masked by the internal combustion engine can cause annoyance in an EV. Electric motor (E-motor) whine noise caused by electromagnetic excitation during E-motor operation is caused by torque ripple and radial excitation. Under high speed and high load operating conditions, the overall sound level may be low, however high frequency whine noise can impair the vehicle level NVH performance. An example of a previously masked unexpected noise phenomenon is a droning noise that can be caused by manufacturing quality variation of the spline coupling between the rotor shaft of the E-motor and the input shaft of the reducer. It is dominated by multiple higher orders of the E-motor rotation frequency.</div><div>In this study, the high speed and high load condition whine noise problem was reproduced through electromagnetic and structural analysis. The countermeasures (E-motor geometry refinements to reduce the excitations and mechanical system transfer path modifications to reduce the vibration response) were defined and the effects investigated. Mechanical system modification to improve NVH performance without increasing the mass is challenging. However, E-motor air-gap geometry optimization, such as slot opening modulation and rotor notch modifications achieved significant noise reduction without critical trade-off of other performance.</div><div>This paper also describes the basic improvement plan proposed through the simulation of the droning noise behavior. The main two manufacturing errors (pitch error in the spline coupling and the alignment error between the rotor and the gearbox shafts) that are responsible for the unexpected droning noise were identified. Using simulation it was shown that the droning noise can be reduced through improved quality control and tolerance design optimization of factors such as axis self-alignment and spline gear tooth quality.</div></div>

Rattle detection in powertrain transmissions based on vibro-acoustical measurements

Investigation of Noise Characteristics of Electric Vibrator Utilizing Acoustic Camera and Transfer Path Analysis

Design of tractor vibration testing system

Application of Acoustic Transfer Vector Algorithm on Acoustic Radiation for Drive Axle of Automobile

A Study on the Noise and Vibration Testing System for Automotive Final Drive

An Experiment System for Vibration Sources Identification with Independent Component Analysis

Evaluation of vibration behavior at different sensing positions on gearboxes

Multidimensional Data Interpretation of Vibration Signals Registered in Different Locations for System Condition Monitoring of a Three-Stage Gear Transmission Operating under Difficult Conditions

Identification and Evaluation of Diesel Engine Noise Source Based on Acoustic Intensity

Vibration characteristics of gear rattling in speed increasing transmission system

Active vibration control of gearbox housing using inertial mass actuators

Correlation of the sound quality and vibration of end of line testing for automatic transmission

Identify the Sources of Vibration and Noise on Cars Gearbox by Spectral Analysis

Vibro-acoustic propagation of gear dynamics in a gear-bearing-housing system

Robust Development of Electric Powertrain NVH for Compact Electric SUV

Methods of detection and localization of the sources of noise and vibration on car gearboxes: a review

A New Vibration Signal Processing Method for Gearbox Fault Detection

Optimization for squeak and rattle reduction using vibration analysis of passenger car door trim

Quantification of Condition Indicator Performance on a Split Torque Gearbox

Semi-active vibro-acoustic control of vehicle transmission systems using a metal rubber-based isolator

Simulation and Experimental Research on Vibration and Noise of Transmission