Abstract:Frequency synthesizers are critical for millimeter-wave (mm-wave) frequency-modulated continuous-wave (FMCW) radars. Large-chirp-bandwidth ($BW_{chirp})$ sawtooth waveforms are required to be synthesized with fast slope and high-frequency linearity for accurate detection of targets or high-quality imaging. Fractional-N phase-locked loops (PLLs) with a two-point-modulation (TPM) scheme are widely used to synthesize fast high-linearity chirps [1] –[3]. However, for a wideband multi-bank digitally controlled oscillator (DCO), the intrinsic $1/ \\surd L\\mathrm{C}$ nonlinearity and the frequency discontinuity from overlaps between adjacent tuning bands introduce a significant gain mismatch between the two modulation paths of the TPM scheme and degrade the chirp linearity [3], [5]. To linearize the DCO tuning curve, a piecewise linear pre-distortion method is commonly used as shown in Fig. 32.5.1 [3]. In this method, the overlaps are mitigated by scaling every band with the same factor SC, which is based on the assumption that ratios of each DCO tuning band to the corresponding coarse frequency step remain the same. In practice, precise matching between these bands cannot be guaranteed. Each tuning band is then linearly fitted with its average gain $g_{i}$, but non-ideal residual frequency errors may still deteriorate the chirp linearity. As a DCO bandwidth increases, the mismatches and residual frequency errors tend to be more severe, making this method unsuitable for wideband FMCW synthesizers.

A Modeling Approach For Mixed-Mode Fmcw Synthesizer Allowing Frequency Error Analysis

Analytical Modeling of Resonant Converters in Frequency Domain for Wireless Power Transfer: Continuous Current Mode (CCM) Operation

First Order Frequency-Domain Analytical Model for Resonant Converters in CCM

Modeling method of finite-difference time-domain based on frequency network models of active devices

Duality-Based Error Estimation and Mesh Adaptation in Electromagnetic Modelling

High Accuracy Microwave Frequency Measurement Based on Single-Drive Dual-Parallel Mach-Zehnder Modulator

AN EQUIVALENT CIRCUIT MODELING METHOD FOR ULTRA-WIDEBAND ANTENNAS

A Coupled Efficient and Systematic Full-Wave Time-Domain Macromodeling and Circuit Simulation Method for Signal Integrity Analysis of High-Speed Interconnects

Wide-Band Modeling On-Chip Spiral Inductors Using Frequency-Dependent Conformal ADI-FDTD Method

Modelling of received ultrasonic signals based on variable frequency analysis

Modeling and Simulation to the Design of EA Fractional-N Frequency Synthesizer

Method for system-level signal and power integrity modeling of high-speed electronic packages

A 24ghz Self-Calibrated Adpll-Based Fmcw Synthesizer With 0.01% Rms Frequency Error Under 3.2ghz Chirp Bandwidth And 320mhz/Mu S Slope

A 24 GHz Self-Calibrated All-Digital FMCW Synthesizer with 0.01% RMS Frequency Error under 3.2 GHz Chirp Bandwidth and 320 MHz/µs Chirp Slope

Modeling and Simulation to the Design of ΣΔ Fractional-N Frequency Synthesizer

Multi-mode Sequence Modeling Method for Accurate Description of VHF Resonant Converters Based on Mixed Logical Inequalities

A Study of Advanced Modeling Methodology of CMOS-compatible RF-MEMS Devices for Integrated Circuit Design

A PHYSICS-BASED HIE-FDTD METHOD FOR ELECTROMAGNETIC MODELING OF MULTI-BAND FREQUENCY SELECTIVE SURFACE (INVITED)

An Efficient Mm-Wave Integrated Circuit Synthesis Method With Accurate Scalable Passive Component Modeling

Frequency-Modulated Signal Measurement Using Closed-Loop Methodology

Equivalent Circuit Modeling of a Transmission Mode FSS Structure with Anisotropic Substrate and Enhanced Parameters