Abstract:Compliance control is required in the applications of robots for assembling, grinding, polishing and human-robot interface, which needs both position control and force control of robots. The impedance control based on joint torque servo is a promising and practical method to realize compliance control in industrial applications. The performance of a joint torque servo controller is thus crucial to the success of compliance control. However, both nonlinear friction torque of the joint motor and varied dynamics of environmental contact during manipulation increase control difficulty greatly. This paper focuses on the compliance control problem and presents a new joint torque servo controller which is a cascading structure including an inner velocity feedback loop and an outer torque control loop. Due to the high signal-to-noise ratio of the motor velocity, an extended state observer is designed to effectively estimate and compensate for the motor friction torque, varied dynamics of environmental contact and other unknown disturbance. And benefiting from the introduction of the efficient and powerful velocity inner loop, the new torque controller performs very well not only in the rigid but also elastic contact environment. Then a standard PD controller is designed in the outer torque loop to produce the control law. Based on the satisfactory joint torque controller, a simplified impedance control algorithm is designed to achieve the force control. Experiments with three other joint torque controllers on a robot manipulator are conducted to demonstrate the proposed joint torque method and the overall force control framework. These results show the proposed joint torque controller can reduce the steady-state error from 3.07 Nm to 0.21 Nm which indicates the joint actuator friction can be eliminated by more than 99%. And a substantial improvement can also be observed in the experiments of force control based on the new joint torque controller.

Research of the Torque Compensation Method for the Vibration Suppression of the Industrial Robot

Torque Limitation Control of Industrial Manipulators Based on General Weighted Least Norm Method

Walking Vibration Suppression for Humanoid Robot Based on Optimal Control

Model Prediction and Optimization of Belt Drive System Vibration Suppression Based on Industrial Robot Joints

Adaptive PID Saturate Output Feedback Control of Robot Manipulators

Active Vibration Adaptive Fuzzy Backstepping Control of a 7-DOF Dual-Arm of Humanoid Robot with Input Saturation

A Novel Robotic Motion Control Strategy Based on Improved Fuzzy PID and Feedforward Compensation

A novel control strategy for vibration reduction in the permanent magnet motor drive system with eccentric load

A Position Control Based on Active Disturbance Rejection Controller Considering Parameter Variations of Harmonic Drive Gear Systems

A Vibration Mitigation Approach for Inverter-fed Permanent Magnet Motor Drive System

Nonlinear Compensation Control For High-Speed Industrial Robot

Vibration Suppression for Improving the Estimation of Kinematic Parameters on Industrial Robots

Desired compensation adaptive robust repetitive control of a multi-DoFs industrial robot

Suppress Vibration on Robotic Polishing with Impedance Matching

Linear System Identification and Vibration Control of End-Effector for Industrial Robots

Reference input design of dual-mode vibration suppression control for 2DOF horizontal robot arm

Compliance Control for Robot Manipulation in Contact with a Varied Environment Based on a New Joint Torque Controller

A Method to Regulate the Torque of Flexible-Joint Manipulators with Velocity Control Inputs

Research on Torque-Variable Control Method for Stepping Motors in Service Robot Arm

Vibration suppression of collaborative robot based on modified trajectory planning