Abstract:High power density is one of the development directions of photovoltaic systems. In order to achieve this goal, the efficiency of converters should be further improved; the loss of power devices should be further reduced; and the volume of the AC side filter should be further reduced by increasing the switching frequency. However, the performance of Si-based converters cannot well meet the development requirements. A clear trend in today's research is to increase the switching frequency and reduce power device losses by using wideband gap (WBG) devices which have much lower switching losses. Nowadays, the manufacturing process of SiC devices is gradually matured. But the latest price of SiC device is still several times higher than that of Si device, which limits its wide application. Thus, it is more practical to replace only a part of the devices in a converter with SiC MOSFETs. This paper presents two application schemes for SiC & Si hybrid modules to reduce losses, increase switching frequency, and increase power density based on three-level ANPC topology. Scheme 1 is the topology with four SiC MOSFETs and two Si IGBTs. Scheme 2 is the topology with two SiC MOSFETs and four Si IGBTs. The modulation strategies applicable to the two schemes are illustrated respectively, and the losses of the two schemes are analyzed and compared. This article also proposes a new calorimetric loss measurement method. The proposed measurement device is simple with just a cuboid metal block and two thermocouples. The steady state temperature difference of the cuboid metal block is chosen as the measurement value, ignoring the effects of ambient temperature changes and easy to achieve accurately. Thermal-circuit model are established to explain the proposed measurement principle. Based on a comprehensive consideration of the loss and cost of the two schemes, this paper optimizes one of the schemes to perform a loss measurement experiment using the proposed loss measurement method.

Low Loss Intelligent Power Module with TFS-IGBTs and SiC SBDs.

A Three-Phase-Module-Parallel Si & SiC Hybrid Inverter with Smaller Filter Size and Low Cost

Hybrid SiC-Si DC–AC Topology: SHEPWM Si-IGBT Master Unit Handling High Power Integrated with Partial-Power SiC-MOSFET Slave Unit Improving Performance

High Performance SiC Power Module Based on Repackaging of Discrete SiC Devices

A High Performance Power Module Based on FSBB20CH60 in Aircon

Full-Integrated Power Module for Motor Drive Applications

A Novel 3.6kV/400A SiC Intelligent Power Module (IPM)

Performance Evaluation of High-Power SiC MOSFET Modules in Comparison to Si IGBT Modules

1.2 Kv/400 A SiC Source Turn-Off MOSFET Intelligent Power Module

Sic Mosfet Zero-Voltage-Switching Svm Controlled Three-Phase Grid Inverter

400Khz, 300W SiC BJT Based High Power Density PFC Converter

800V Lateral IGBT in Bulk Si for Low Power Compact SMPS Applications

An SiC MOSFET & Si Diode Hybrid Three-Phase High-Power Three-level Rectifier

Loss Analysis and Measurement of ANPC Inverter Based on SiC & Si Hybrid Module

A 1200 V/200 A Half-Bridge Power Module Based on Si IGBT/SiC MOSFET Hybrid Switch

A Quasi-Two-Level Medium-Voltage SiC MOSFET Power Module with Low Loss and Voltage Self-Balance

Design and Application of A 1200v Ultra-Fast Integrated Silicon Carbide Mosfet Module

3.38 Mhz Operation of 1.2kv SiC MOSFET with Integrated Ultra-Fast Gate Drive

IGBT Dynamic Loss Reduction Through Device Level Soft Switching

A Hybrid Modular Multilevel Converter Comprising Si Submodules and SiC Submodules with Its Specialized Capacitor Voltage Balancing Strategy