Abstract:The submerged membrane bioreactor (sMBR) is being increasingly applied for municipal and industrial wastewater treatment. This paper examines the role of sludge retention time (SRT), an important operating parameter of the MBR as it affects the biological characteristics of the sludge and therefore influences membrane fouling. Well controlled runs were carried out at short SRT (10days) and moderate SRT (30days) in a 30 L submerged MBR equipped with KUBOTA flat-sheet membranes. At steady operation, the mixed liquor suspended solids (MLSS) stabilized at approximately 5-6 g/L and 8.5-10 g/L for SRT 10 and 30days respectively. The DGGE profiles suggested a shift in the dominant bacterial community with the prolonged SRT. The soluble microbial products (SMP) were 9.3 mg/L and 5.4 mg/L at the SRTs of 10days and 30days respectively. The total amount of extracellular polymeric substance (EPS) extracted from the floc and the supernatant was approximately constant at the two SRTs under the same organic loading rate. However, the polysaccharide concentration in the supernatant was about 100% higher for the SRT of 10days than that for 30days. The viscosity of the biomass increased with the prolonged SRT, while the estimated average air induced water velocity was similar for the two SRTs. The results of flux stepping tests showed that the membrane fouling rate (dTMP/dt) at SRT 10days was always higher than that at 30days at each flux step. Similarly, long term experimental runs at a constant flux of 20 L/m(2) (.) h clearly showed more severe membrane fouling for the SRT of 10days than that at 30days. This implies that fouling is more influenced by the concentration of SMP and Polysaccharides than the MLSS.

Effect of Solid Retention Time on Membrane Fouling in Membrane Bioreactor: from the Perspective of Quorum Sensing and Quorum Quenching

Effect of Sludge Retention Time on Membrane Bio‐Fouling Intensity in a Submerged Membrane Bioreactor

Effects of sludge retention time on sludge characteristics in membrane bioreactors

Influences of Sludge Retention Time on Sludge Properties and Membrane Fouling of Submerged Membrane Bioreactor with the Addition of Ca2+

Effects of Sludge Retention Time on the Characteristics of Mixed Liquor and Membrane Fouling in Membrane Bioreactor

The effect of solids retention times on the characterization of extracellular polymeric substances and soluble microbial products in a submerged membrane bioreactor.

Impacts of sludge retention time on sludge characteristics and membrane fouling in a submerged anaerobic–oxic membrane bioreactor

Effect of Hydraulic Retention Time on Membrane Fouling and Biomass Characteristics in Submerged Membrane Bioreactors

Sludge rheological and physiological characteristics in a pilot-scale submerged membrane bioreactor

Impact of short mean cell residence time on biofouling and bacterial community in a membrane bioreactor

Study on the impact of sludge components on membrane fouling in a sub-merged membrane bioreactor

Effects of SRT on LB-EPS and Membrane Fouling in a HMBR

InfIuences of SRT on S-EPS and membrane fouIing in a HMBR

Effect of sludge retention time on microbial behaviour in a submerged membrane bioreactor

Study on membrane fouling of submerged membrane bioreactor in treating bathing wastewater.

Study on membrane fouling caused by activated sludge from a membrane bioreactor with long solid retention time

Effective Control of Membrane Fouling by Filamentous Bacteria in a Submerged Membrane Bioreactor

Study on change of sludge mixed liquor characteristics and membrane fouling in MBR

Insights into the Effect of Sludge Retention Times on System Performance, Microbial Structure and Quorum Sensing in an Activated Sludge Bioreactor

Relationship Between Sludge Characteristics and Membrane Flux Determination in Submerged Membrane Bioreactors

Influence of Fluorescent Substances on Membrane Fouling in Membrane Bioreactors (MBR)