Abstract:Sludge characteristics of a submerged membrane bioreactor (MBR) and an activated sludge process (AS) were compared, during a first phase at the same operating conditions (low MLSS and conventional SRT) and in a second phase with a high sludge retention time (SRT) in the membrane bioreactor. During the first phase, a bimodal flocs size distribution was observed in the MBR with simultaneously a macro-flocs population (240 microm) bigger than the flocs of activated sludge due to the absence of recirculating pump, and also more microflocs (1 to 15 microm) and free suspended cells retained by the membrane. It is shown that the membrane leads to an accumulation of proteins and polysaccharides in the sludge supernatant which is probably responsible for the high fouling propensity of the sludge during the starting period of MBR. These compounds are partially degraded after 50 to 60 days of operation. In the first phase respirometric experiments didn't demonstrate a significant difference in the maximal removal rates of either MBR or AS biomass (with excess substrate), except in the dynamic period during which the membrane retention gave an advantage by increasing the biomass activity. On the other hand, the respirometry shows that the half saturation constant for nitrification was significantly higher in the MBR process, suggesting higher substrate transfer limitation. During the last phase, it is shown that an increase of SRT from 9 to 106 days leads to a diminution of average macro-flocs size in the MBR from about 240 to 70 microm. With the SRT increase, modification in the organic compounds is also observed (proteins, polysaccharides and COD) in the sludge supernatant. Increasing the SRT from 9 to 40 days seems to slightly reduce the level of organic compounds (probable biodegradation), but the concentrations increased when SRT changes from 40 days to 106 days (probable accumulation of non biodegradable compounds).

Effects of Sludge Retention Time on the Characteristics of Mixed Liquor and Membrane Fouling in Membrane Bioreactor

Effects of sludge retention time on sludge characteristics in membrane bioreactors

Influences of Sludge Retention Time on Sludge Properties and Membrane Fouling of Submerged Membrane Bioreactor with the Addition of Ca2+

Effects of SRT on LB-EPS and Membrane Fouling in a HMBR

Study on change of sludge mixed liquor characteristics and membrane fouling in MBR

Performance and Membrane Fouling of a Step-Fed Submerged Membrane Sequencing Batch Reactor Treating Swine Biogas Digestion Slurry

Study on membrane fouling of submerged membrane bioreactor in treating bathing wastewater.

InfIuences of SRT on S-EPS and membrane fouIing in a HMBR

Impacts of sludge retention time on sludge characteristics and membrane fouling in a submerged anaerobic–oxic membrane bioreactor

Effect of carbon to nitrogen ratio of feed wastewater and sludge retention time on activated sludge in a submerged membrane bioreactor

Effect of sludge retention time on microbial behaviour in a submerged membrane bioreactor

Effect of Aeration Intensity on Operating Characteristics of Membrane Bioreactors

Effect of Extracellular Polymeric Substances in SMBR on Membrane Filtration

Characterization of sludge structure and activity in submerged membrane bioreactor

Notice of Retraction: Study on Characteristics of Sludge Mixed Liquor and Microbial Population Succession in Membrane Bioreactor Without Sludge Purge

Impact of SRT on the Polluted Organic Substance Removing Rate in MBR

Effects of Solids Retention Time on the Performance and Microbial Community Structures in Membrane Bioreactors Treating Synthetic Oil Refinery Wastewater

Mechanism of membrane fouling and filtration characteristics in a membrane bioreactor for industrial wastewater treatment

Impact of short mean cell residence time on biofouling and bacterial community in a membrane bioreactor

An A/O submerged membrane bioreactor and its membrane fouling research in treating bathing wastewater

Microbial behaviors involved in cake fouling in membrane bioreactors under different solids retention times.