Abstract:In the Tunnel Boring Machines (TBMs) construction of soft rock tunnels, adverse geological conditions, such as water-rich and wet strata are often encountered. Water in strata can change the stress state and weaken the mechanical performance of rock mass, further affecting the tunneling process and rock breaking efficiency. To study the effect of water content on mudstone fragmentation characteristics and cutter force during TBM cutter indentation, the water softening effect is considered in the moisture diffusion-fracture coupling model based on the finite-discrete element method (FDEM). Then, the micro parameters (fracture energy release rate, swelling coefficient and moisture diffusion coefficient) of mudstone are calibrated by uniaxial, triaxial compression and swelling tests. Subsequently, the water content and swelling deformation evolution of mudstone samples during water migration are revealed. Finally, the coupling model is utilized to investigate the fragmentation characteristics and cutter force of mudstone samples with different water contents under various confining pressures during TBM cutter indentation. The fragmentation zone, cutter force, acoustic emission (AE), and crack number during cutter indentation are quantitatively analyzed. Results indicate that the vertical extent of fragmentation range ( E v ) decreases with the increase of water content, while the horizontal extent of fragmentation zone ( E h ) does not decrease obviously until the water content reaches 3%. The increase of confining pressure reduces the effect of water content on E v , and the increase of water content also reduces the effect of confining pressure on E v , indicating that confining pressure and water content have a mutual inhibition effect on E v . Besides, both the peak value of normal force and the fluctuation range of tangential force for the TBM cutter decrease with the increase of the water content. The AE counts show that the failure pattern of mudstone is mainly shear failure during TBM cutter indentation. Specifically, many shear cracks are generated in the compression zone under the cutter, while few tensile cracks propagate in mudstone on both sides and deeper below the cutter. For mudstone under different confining pressures, the proportion of shear cracks increases with the increase of water content. Moreover, the effect of cutter penetration velocity on mudstone fragmentation characteristics and cutter force is discussed. The results in this paper have theoretical guidance for TBM construction of soft rock tunnels in water-rich and wet strata.

Large-scale field model testing of the effects of soft rock water content on the bearing performance of tunnel-type anchorages

Instability Mechanism of Shallow Tunnel in Soft Rock Subjected to Surcharge Loads

Study Of Surrounding Rock Damage Induced By Tunnel Boring Machine Driving Tunnel At West Route Of South To North Water Transfer Project

Large-scale geo-mechanical model tests for stability assessment of super-large cross-section tunnel

A Field Model Test Method of Tunnel-Type Anchorages in Rock Mass and Its Application in Railway Suspension Bridge Engineering

Analysis of deformation control mechanism of prestressed anchor on jointed soft rock in large cross-section tunnel

Model Test Studies on Ground Subsidence and Cracks Induced by Tunneling in Weak Rock Mass with High Water Content

Construction practice of water conveyance tunnel among complex geotechnical conditions: a case study

Physical and Mechanical Characteristics of Soft Rock Tunnel and the Effect of Excavation on Supporting Structure

Experimental investigation on stress-induced failure in D-shaped hard rock tunnel under water-bearing and true triaxial compression conditions

Model test on the behavior of tunnel linings under earth pressure conditions and external water pressure

Study on failure mechanism of tunnel-type anchorage using discontinuous deformation analysis method

Model test on deformation and failure mechanism of tunnel support with Layered rock mass under high ground stress

Geo-mechanical model test on excavation and support of deep tunnel crossing a fault under hydro-mechanical coupled condition

Mechanisms of Large Deformation in Soft Rock Tunnels: a Case Study of Huangjiazhai Tunnel

Deformation mechanism of rock mass and prestressed anchor cable support technology of Haidong soft rock tunnel

Numerical analysis of the influence of a river on tunnelling-induced ground deformation in soft soil

Surrounding rock instability mechanism for fault-crossing tunnels in water-rich soft rock

3D Geomechanical Model Tests on Asymmetric Reinforcement and Overall Stability Relating to the Jinping I Super-High Arch Dam

Insights into the Effect of Water Content on Mudstone Fragmentation and Cutter Force during TBM Cutter Indentation via the Combined Finite-Discrete Element Method

Experimental Study on Deformation and Failure Characteristics and Monitoring and Early Warning of Surrounding Rock of Tunnel Crossing Sliding Surface