Abstract:With the rapid development of the semiconductor industry, fault diagnosis is an important task in routine operations to determine the root cause for faults that occur. A tool in manufacturing processes is equipped with a wide variety of sensors that record different types of process data. Wafers being processed are accompanied by a considerable amount of process data as a multivariate time series. Identifying the key process parameters and the corresponding process operations where faults occur can be used to facilitate the tasks of monitoring the process, maintaining the stability of the process, and stabilizing wafer production yield. This article proposes a novel solution procedure for fault diagnosis of wafer acceptance test (WAT) and chip probing (CP) using machine learning (ML). Based on the process flow of wafers and the corresponding process data, a sampling method, called synthetic minority oversampling technique (SMOTE), is first used to augment classification models with an imbalanced process dataset, and the best-practice SMOTE ratio is sought by using four competitive classifiers. By means of principal component analysis (PCA), the original data are transformed into visualizations to explore the distributions of good and bad lots of wafers. Based on the comparison of the four classifiers used in the test, the proposed logistic regression with data augmentation (LR-SMOTE) performs best. The ten most important features identified by using the LR are collected to determine potential failure operations. The identified failures in operations returned by using the proposed solution procedure for fault diagnosis of WAT and CP were confirmed by the engineers who work in the domain. Note to Practitioners—In semiconductor manufacturing practice, during the WAT and CP, domain engineers need to trace upstream the key process parameters and the corresponding key operations in the front-end-of-line (FEOL) process if any faults are detected in the -ack-end-of-line (BEOL) process. In fact, the FEOL and the BEOL are located in completely separate plants with different clean room standards. Bridging the information gap between these two different processes merits thorough scrutiny. Another challenge posed by fault diagnosis of WAT and CP is that the total number of features (i.e., process parameters) involved in the FEOL can be tens of thousands, leading to an adverse effect of data sparsity on model building.

An Improved Fault Transfer Table Based Fault Modeling Method in Etch Process of Semiconductor Wafer Manufacturing System

Fault Diagnosis in Chemical Processes Based on WPA and WLS-SVM

Scratch-Concerned Yield Modeling for Ic Manufacturing Involved with A Chemical Mechanical Polishing Process

Structured Fault Information-Aided Canonical Variate Analysis Model for Dynamic Process Monitoring

A composite algorithm of lithography process in AlGaN/GaN-on-SiC HEMTs manufacturing

A sub-principal component of fault detection (PCFD) modeling method and its application to online fault diagnosis

An Effective Fault Diagnosis Approach Based on Optimal Weighted Least Squares Support Vector Machine

Improved Threshold for the Local Approach in Detecting Faults

Fault Diagnosis of Wafer Acceptance Test and Chip Probing Between Front-End-of-Line and Back-End-of-Line Processes

A Study on Process Diagnosis Technology to Improve the Reliability of the Etching Process

Development of Fault Detection Systems Based on Big Data Ecosystem in Semiconductor Manufacturing: The Hadoop Ecosystem Implementation

An adaptive Copula function-based framework for fault detection in semiconductor wafer fabrication

A Generation Algorithm and Its Application for Fault Model Established with Data Flow Graph

Machine Learning Based Wafer Defect Detection

Chemical Process Fault Simulation Analyses Based on an Extended SDG

Data-driven fault model development for superconducting logic

Incipient Fault Detection Based on Fault Extraction and Residual Evaluation

A Copula network deconvolution-based direct correlation disentangling framework for explainable fault detection in semiconductor wafer fabrication

The Inspection and Solution of Inline CT Defect for 28NM Process Improvement

Fault Subspace Selection Approach Combined with Analysis of Relative Changes for Reconstruction Modeling and Multifault Diagnosis

Using intelligent technology and real-time feedback algorithm to improve manufacturing process in IoT semiconductor industry