Abstract:Aiming at the experimental test of the body freedom flutter for modern high aspect ratio flexible flying wing, this paper conducts a body freedom flutter wind tunnel test on a full-span flying wing flutter model. The research content is summarized as follows: (1) The full-span finite element model and aeroelastic model of an unmanned aerial vehicle for body freedom flutter wind tunnel test are established, and the structural dynamics and flutter characteristics of this vehicle are obtained through theoretical analysis. (2) Based on the preliminary theoretical analysis results, the design and manufacturing of this vehicle are completed, and the structural dynamic characteristics of the vehicle are identified through ground vibration test. Finally, the theoretical analysis model is updated and the corresponding flutter characteristics are obtained. (3) A novel quasi-free flying suspension system capable of releasing pitch, plunge and yaw degrees of freedom is designed and implemented in the wind tunnel flutter test. The influence of the nose mass balance on the flutter results is explored. The study shows that: (1) The test vehicle can exhibit body freedom flutter at low airspeeds, and the obtained flutter speed and damping characteristics are favorable for conducting the body freedom flutter wind tunnel test. (2) The designed suspension system can effectively release the degrees of freedom of pitch, plunge, and yaw. The flutter speed measured in the wind tunnel test is 9.72 m/s, and the flutter frequency is 2.18 Hz, which agree well with the theoretical results (with flutter speed of 9.49 m/s and flutter frequency of 2.03 Hz). (3) With the increasing of the mass balance at the nose, critical speed of body freedom flutter rises up and the flutter frequency gradually decreases, which also agree well with corresponding theoretical results.

Body Freedom Flutter Study and Passive Flutter Suppression for a High Aspect Ratio Flying Wing Model

Full-Span Flying Wing Wind Tunnel Test: A Body Freedom Flutter Study

Body Freedom Flutter Investigation Using Different Commercial Softwares

Flutter Modeling, Analysis and Test for Blended-Wing-Body Flying Wing

Body Freedom Flutter of a Blended Wing Body Model Coupled with Flight Control System

The Development of a Flight Test Platform to Study the Body Freedom Flutter of BWB Flying Wings

Wind tunnel experiments of bending-torsion and body-freedom flutter on flying wing unmanned aerial vehicles

Time-Domain Analysis of Body Freedom Flutter Based on 6DOF Equation

Body-freedom Flutter Analysis and Flight Test for a Flying-Wing Aircraft Testbed

Parametric Aeroelastic Modeling and Flutter Analysis for a Folding Wing

An effective computer modelling approach to the study of aeroelastic characteristics of an aircraft composite wing with high aspect ratio

Effect of the Wing Morphology and Structural Form on the Flexible Hovering Flapping Wing

Research on Flutter Characteristics and Stiffness Design for 15 Meters Span Wing of a Solar-powered Aircraft

Nonlinear Flutter Studies on Control Surface Freeplay

Active Flutter Suppression of Wing with Morphing Flap

Parametric Studies on Nonlinear Flutter of High-Aspect-Ratio Flexible Wings

Simulation and Flutter Analysis of Wing Folding Process of Folding Wing Aircraft

Robust Active Suppression for Body-Freedom Flutter of a Flying-Wing Unmanned Aerial Vehicle.

Modeling, Design, and Flight Testing of Three Flutter Controllers for a Flying-Wing Drone

Study of aeroelastic tailoring of high-aspect-ratio flexible composite wing

Influence of Different Take-Off Weights on the Longitudinal Dynamic Stability of Flapping-Wing MAVs