Abstract:To increase the accuracy of an analytic method based on the concentrated-mass approach for solving the mechanical operating modal characteristics of complete impellers and impellers with balancing holes in a centrifugal-pump rotor system, we establish a mathematical model and a three-dimensional simulation model for a double-supported three-stage centrifugal-pump rotor system. By comparing the modal results obtained from the two models, we propose a mathematical model that integrates the optimization of mass-distribution methods and bending stiffness correction coefficients, and we derive an optimized mathematical model for rotors with balancing holes. The effectiveness of the optimized mathematical model is validated via three-dimensional simulation, and the influence of balancing holes on the wet modes is analyzed. The results show that the wet natural frequencies are lower than the dry ones and that the wet natural frequencies obtained from analytical calculations are consistently higher than those obtained from three-dimensional simulation results. The optimized mathematical model significantly improves the accuracy of the wet modal characteristics for both complete impellers and impellers with balancing holes, with the errors in the low-order natural frequencies reduced by more than 50%. Under the same hole spacing, the natural frequencies of the three-stage centrifugal pump rotor system decrease with increasing hole diameter slightly. Under the same hole diameter, the natural frequencies of the rotor system increase slightly with the hole spacing. The effect of stiffness changes caused by balancing holes on the natural frequencies is larger than the effect of mass changes.

Theoretical and Numerical Modal Analysis for Nuclear Coolant Pump and its Scaled Rotor System

Research of Modal Analysis for Impeller of Reactor Coolant Pump

Modeling a Two-Span Rotor System Based on the Hamilton Principle and Rotor Dynamic Behavior Analysis

Numerical Theory and Method on the Modal Behavior of a Pump-Turbine Rotor System Considering Gyro-Effect and Added Mass Effect

Analysis of Pressure Pulsation Induced by Rotor-Stator Interaction in Nuclear Reactor Coolant Pump

Mechanics mode characteristics analysis and numerical analytical optimization study of a three-stage centrifugal pump

Comparative Study on Numerical Calculation of Modal Characteristics of Pump-Turbine Shaft System

Dynamic analysis of the pump system based on MOC–CFD coupled method

Numerical Simulation of the Cavitation Characteristics of A Mixed-Flow Pump

Inception behavior of the cavitation in nuclear reactor cooling pump

An analytical method for free vibrations of the fuel rod with non-uniform mass of small modular reactor

Finite Element Analysis of the Rotor System of a Magnetically Suspended Compound Molecule Pump

ICONE11-36524 PRELIMINARY MODAL ANALYSIS AND STRUCTURE DESIGN OF AN HTR-10 PCU ROTOR WITH AN ACTIVE MAGNETIC BEARING

A Comparative Study on Coupled Fluid–Thermal Field of a Large Nuclear Turbine Generator with Radial and Composited Radial–Axial–Radial Ventilation Systems

A partial similitude method considering variable powers in scaling laws and applied to rotor-bearing systems

Dynamic Analysis of a Planar Multi-Stage Centrifugal Pump Rotor System Based on a Novel Coupled Model

Numerical Analysis on the Modal Characteristics of a Pumped Storage Unit Runner in Cavitating Flow

Influence of the Impeller/Guide Vane Clearance Ratio on the Performances of a Nuclear Reactor Coolant Pump

An Improved Concentrated Mass Method for Analysis of the Mechanics Modes of a Four-Stage Pump Rotor System

Numerical Method for Computing Modal Damping of Rotor System

Scaling Design and Similarity Analysis of a Floating Nuclear Power Plant