Abstract:Wear performance and mechanisms of PCBN tools with different CBN content (80% vol. and 95% vol.) and cutting edge geometry (honed edge radius, 0.05 mm chamfered edge width, and 0.10 mm chamfered edge width) in boring powder metallurgy (PM) steels had been evaluated. Post-cutting examination of the worn cutting inserts was performed using focus variation microscopy (FVM), scanning electron microscopy (SEM), and energy dispersive spectrometer (EDS). The advanced three-dimensional wear characterization parameters WRM, WMD, WAM, WMH, and WAA are used to measure the wear of PCBN tools. A novel characterization method of removed material (η1 = WMD/WRM) and adhered material (η2 = WMH/WAM) was used to measure the trend of tool wear in this paper. With the increasing of CBN content, the PCBN tool wear parameters WRM, WMD, and WAA were decreased; adhesion was increased by WAM and WMH parameter characterization. For the variation of cutting edge geometry, chamfered edge showed a higher tool life and better wear performance than honed edge radius. With the increasing of chamfered edge width from 0.05 to 0.10 mm, the three-dimensional wear WRM, WMD, WAM, and WMH were increased. WAA showed an opposite trend and parameters η1 and η2 showed a not convergence trend. Besides typical wear mechanisms such as diffusion, adhesion, abrasive, microchipping was observed on PCBN tool; the tool protection layer (TPL) formation and peeling and impact load could be the reasons to explain the microchipping that occurred on cutting edge. Tool life is measured by surface roughness and calculated according to the number of workpieces processed. The results showed that PCBN tool with 95% vol. CBN content and 0.10 mm chamfered edge width achieves higher tool life.

Wear Behaviors of Pcbn Tools in Interrupted Turning Hardened Steel with Tool'S Chamfer Angle and Edge Preparation Considered

Wear Behaviors of Pcd Tools in Turning Granite

Cutting Performance and Wear/Damage Characteristics of PCBN Tool in Hard Milling

Wear performance and mechanisms of PCBN tools in boring of powder metallurgy steels

Experimental Investigation on the Machinability of PCBN Chamfered Tool in Dry Turning of Gray Cast Iron

Investigation on Cutting Performance of Micro-Textured Cutting Tools

Research on PCBN Tool Dry Cutting GCr15

Experimental Study On Performance Of Cbn-Coated, Cbn-Uncoated And Pcd Tools In Turning Al 2124 Sic (45%Wt) Pmmc

Study on cutting performance of double-inclined-wall cosine enhanced PCBN tool

Tool wear characteristics analysis of cBN cutting tools in high-speed turning of Inconel 718

Research On Wear Shape When Cutting Austempered Ductile Iron (Adi) With Pcbn Tools And Ceramic Tools

Cutting performance of cubic boron nitride-coated tools in dry turning of hardened ductile iron

Using Pulse Laser Processing to Shape Cutting Edge of PcBN Tool for High-Precision Turning of Hardened Steel

Performance and wear mechanisms of PCD and pcBN cutting tools during machining titanium alloy Ti6Al4V

Effect of PCBN tool grade and cutting type on hard turning of high-chromium white cast iron

Influence of cutting parameters on PCD tool wear during milling tungsten carbide

Cutting performance and tool wear mechanism of corrugated helical PCD tool in milling Cf/SiC composites

Wear behaviors of cubic boron nitride tools with various binders in high-speed turning of compacted graphite irons

Cutting performance and wear mechanism of spark plasma–sintered silicon nitride ceramics tool in dry turning of 41Cr4 hardened steel

Wear and friction analysis of cubic boron nitride tools with different binders in high-speed turning of nickel-based superalloys

The Study on the Effect of Various Tool Wear Indicators on the Machining of MMCs