Abstract:Enhancing the thermal shock resistance of Y2O3 ceramic crucibles, coupled with advancements in melting and casting technologies to reduce the adverse influence of interfacial reactions, is essential for producing low-energy consumption, high-quality titanium-aluminum (TiAl) alloys. In this study, the Y2O3 ceramic crucible with good thermal shock resistance was developed through the optimization of particle size distribution and sintering holding time. The interaction mechanisms between Y2O3 ceramics and TiAl alloys under extreme conditions were investigated, and strategies for enhancing the mechanical properties of TiAl alloys through the integration of Y2O3 crucibles with centrifugal casting were discussed. The results indicated that introducing large particles of 1-3 mm under sintering conditions of 2023 K and 6 h effectively enhances the thermal shock resistance of Y2O3 crucible. The interaction between Y2O3 and TiAl alloys primarily involved physical erosion (spalling/dispersion), dissolution of separated particles, and surface modification of interface layer particles (reaction). Physical erosion played an important role in this dynamic interaction, with the extent of erosion intensifying through continuous use of the crucible, while electromagnetic forces ensured the uniform distribution of inclusions within the TiAl alloy matrix. Moreover, the application of centrifugal casting technology substantially refines the grain size and reduces the inclusion count, thereby significantly enhancing the mechanical properties of TiAl alloy.

Development of Ceramic Moulds with Zirconia Primary Coat for Investment Casting of Gamma Titanium Aluminide Based Alloys

Microstructure and mechanical properties of TiAl castings produced by zirconia ceramic moulds

Application of zirconia ceramic moulds for investment casting of TiAl alloys

Preparation of Ceramic Moulds with Zirconia Coatings for the Investment Casting of TiAl Alloys

Interactions Between TiAl and ZrO2 Face Coat During Centrifugal Investment Casting

Interfacial reactions between Ti-1100 alloy and ceramic mould during investment casting

Technology Research on the Oxide Ceramic Mould for Investment Casting of TiAl-based Alloys

Interfacial Reactions Between TiAl Alloys and ZrO2 Mould under Centrifugal Investment Casting Conditions

Improvement in Collapsibility of Zro2 Ceramic Mould for Investment Casting of Tial Alloys

Effect of particle size distribution on properties of zirconia ceramic mould for TiAl investment casting

Influence of pouring temperature and mold preheating temperature on investment casting of TiAI

Microstructure and Interface Reaction of Investment Casting Tial Alloys

Interactions between TiAl alloy and AZC/AMT binder systems in investment casting

Alumina-Based Ceramic Core Nano-Composites For Investment Casting

Effects of Adding Aluminum Oxide or Zirconium Oxide Fibers on Ceramic Molds for Casting Hollow Turbine Blades

Towards High-Quality Investment Casting of Ti-6Al-4V with Novel Calcium Zirconate Crucibles and Optimized Process Control

Effect of Chemical Vapour Infiltration Technique on the Gradient Microstructure and High-Temperature Strength of Gel-Cast Al2O3-based Ceramic Moulds

The Study on Interaction Mechanisms Between Ti48al2cr2nb Alloy and Y2o3 Ceramic Crucibles with Good Thermal Shock Resistance: Assessing a Novel, Cost-Effective Approach to the Preparation of High-Performance Tial Alloys

Interactions Between Ti Al Alloy and AZC/AMT Binder Systems in Investment Casting

Effect of in Situ Synthesised Mullite Whiskers on the High-Temperature Strength of Al2o3-Based Ceramic Moulds for Casting Hollow Turbine Blades

Study of Interfacial Reaction Between TiAl Alloys and Four Ceramic Molds