Comparative study of bending performances of spiral triangular strand and simple straight strand based on finite element method
CHEN Yuanpei,CHEN Zhiwei,MENG Peng,MENG Fanming,GONG Xiansheng
DOI: https://doi.org/10.13247/j.cnki.jcumt.000329
2015-01-01
Journal of China University of Mining and Technology
Abstract:The bending performances of spiral triangular strands and simple straight strands were analyzed in this paper,in which factors like strands configuration,elasto-plasticity of steel wire,inter-wire friction and contact were considered.As a consequence,3Dfinite element(FE)models of the strands were established,and the bending performances of the two kinds of strands with same lay angle and total wire sectional area were analyzed and compared.The results show that the elasto-plastic behavior can be found in both kinds of strands under pure bending load,and the hysteresis in the response of the bending moment to the curvature is observed as well.The bending stiffness of the two strands decrease respectively with ratios of0.2%/(°)and 0.8%/(°)as lay angle increases,and increase respectively with ratios of22.3%/mm and 15.5%/mm as outer wire diameter increases.With increasing outer wire diameter,the von Mises stress of the two strands rise respectively with ratios of 0.9%/(°)and0.6%/(°),meanwhile,their plastic deformation also increase respectively with ratios of5.8%/mm and 2.3%/mm.The bending stiffness,von Mises stress,total deformation and plastic deformation of the spiral triangular strand are about 88.0%,89.3%,67.9% and74.6% of those of the simple straight strand.