Abstract:It has been demonstrated that the spontaneous emission rate can be enhanced dramatically by Surface Plasmon Polaritons (SPP) due to large density of states for photon near the SPP resonance frequency and very small mode volume. Some valuable works have been reported to verify such effect with a single metal layer above the semiconductor active layer. However, huge power dissipating to "lossy surface wave (LSW)" mode occurs in such monolayer structure because the enhancement decays with the distance away from the interface exponentially and therefore the active layer should be close enough to the metal film. LSW will convert the energy into heat and make the monolayer structure hardly be applied to obtain large enhancement of spontaneous emission. In this paper, we propose a double-layer structure with two metal films at the top and bottom of semiconductor layer. By assuming the dipole (classical model for the source) at the center of the active layer, which means the distance between the dipole and the interfaces is half of the thickness of active layer, the enhancements of spontaneous emission were calculated and analyzed for both monolayer and double-layer structures with different thickness of the metal film and active layer. The calculation results show that, for the double-layer structure, the critical thickness of the active layer, where the power to SPP exceeds the power to LSW, is much thinner than that in the monolayer structure. This means that the active layer can be set closer to the metal film in the double-layer structure without worrying about the LSW. Therefore, larger enhancement of spontaneous emission rate and higher available energy can be achieved simultaneously.

Enhancement of Amplified Spontaneous Emission in Organic Gain Media by the Metallic Film

Improvement of Amplified Spontaneous Emission Performance in Organic Waveguides

Optical Properties of Unsymmetrical Metal Microcavity in Organic Luminescent Devices

Optical trait of unsymmetrical metal microcavity in organic thin film luminescent devices

Long-term Air-Stable Amplified Spontaneous Emission in Quasi-2D Perovskite Films Through Ligand Engineering

Low Threshold Amplified Spontaneous Emission and Lasing from Single Crystals and Polymer Microspheres Based on a Blue Aggregation-Enhanced Emission Molecule

Enhanced Amplified Spontaneous Emission from Perovskite Films by a Multifunctional 4′‐aminoacetophenone Hydrochloride Additive Assistant Engineering

Improving the random lasing performance using Au@SiO2 nanocubes-silver film hybrid structure

Realization of an Extraordinary Transmission Window for A Seamless Ag Film Based on Metal-Insulator-Metal Structures

Transmission Enhancement Based on Strong Interference in Metal-Semiconductor Layered Film for Energy Harvesting

Optimized dual-band amplified spontaneous emission properties of PFO and BUBD-1 blend films based on AgNPs doped buffer layers

Tuning stimulated emission properties of oligofluorene-based gain media via non-conjugation strategy

Surface Plasmon-Enhanced Amplified Spontaneous Emission from Organic Single Crystals by Integrating Graphene/copper Nanoparticle Hybrid Nanostructures.

Luminescence enhancement of Y2O3 thin films based on LSPR effect of Ag nanolayers

Enhanced Electroluminescence from Silicon-Based Light-Emitting Devices with Mg0.4zn0.6o/Erbium-Doped Zno Heterostructures by Using Ito/Moo3 Combined Anode

Simple Approach to Improving the Amplified Spontaneous Emission Properties of Perovskite Films

Extremely Low Threshold Quasi‐CW Amplified Spontaneous Emission Achieving and Its Mechanism Study

Amplified Spontaneous Emission and Lasing from Zn-Processed AgIn 5 S 8 Core/Shell Quantum Dots

Suppression of the plasmon-quenching effect on light amplification in 20-μm-diameter plasmonic whispering gallery mode resonators fabricated from bowl-shaped organic/metal thin films

Reduction of Lossy Surface Waves in A Double Metal Films Structure

Cocrystallization Tailoring Multiple Radiative Decay Pathways for Amplified Spontaneous Emission