Abstract:The studies of the elastic behavior in the capillary flow of LDPE/HDPE blend melts were carried out at a test temperature range from 180 to 200 degrees C and at an apparent shear rate of about 25-120 s(-1). The end-pressure drop (Delta P-end) increased nonlinearly with increasing wall shear stress (tau(omega)) and achieved a minimum value at a weight fraction (phi(HD)) of HDPE of 50%. The die-swell ratio (B) increased basically linearly with increasing tau(omega) or Delta P-end and achieved a maximum value at phi(HD) of 50%. With the addition of the die length-diameter ratio, the values of B were decreased linearly. At a low shear rate, the temperature sensitivity of the melt die-swell was more significant than at a high shear rate. With increasing phi(HD), B increased when phi(HD) <50%, then decreased. B reached a maximum value at phi(HD), of 50% and a fixed apparent shear rate. This phenomenon may be explained by using the theory of viscoelastic competition between components of polymer blend melts. Furthermore, the first normal stress difference (N-1) of the sample melts was estimated by using an equation published in a previous work. The results showed that B increased linearly with increasing N-1. (C) 2000 John Wiley & Sons, Inc.

Melt Elongation Strength and Drawability of LDPE/LLDPE Blends

Melt Strength and Drawability of HDPE, LDPE and HDPE/LDPE Blends

Melt Elongation Flow Behaviour of LDPE/LLDPE Blends

Melt Elongation Properties of Linear Low-Density Polyethylene

The elastic behaviour during capillary extrusion of LDPE/LLDPE blend melts

Elongational Properties of Low Density Polyethylene Using Melt Spinning Technique

Elastic Behavior of Ldpe/Hepe Blend Melts in Capillary Extrusion

Elongation properties of polyethylene melts

Study on extensional rheological properties of LDPE using melt spinning technique

The Melt Die-Swell Behaviour During Capillary Extrusion of Ldpe/Pp Blends

Elongational Rheology of Lldpe by Melt Spinning Technique

Studies on Melt Flow Properties of Low Density and Linear Low Density Polyethylene Blends in Capillary Extrusion

Melt flow properties of LDPE/HDPE blends in capillary extrusion

Melt Spinning Flow Behaviour of High-Density Polyethylene Blended with Low-Density Polyethylene

Melt Flow Properties During Capillary Extrusion of Linear Low-Density Polyethylene

An Analysis of Melt Spinning Master-Curves of Low-Density Polyethylene/linear Low-Density Polyethylene Blends

Extensional rheology of LDPE from melt spinning technique

Effects of Extrusion Conditions on Melt Viscoelasticity During Capillary Flow of Low-Density Polyethylene

Melt strength and stretching ratio of low-density polyethylene composites loaded with nanoscale zinc oxide

Low density polyethylene-polypropylene blends: Part 1 - Ductility and tensile properties

Characterization of Elongation Viscosity for Polyethylene Melts