Abstract:Multimode ytterbium-doped optical fibers (YDFs) are increasingly utilized in military applications involving fiber lasers and amplifiers. YDFs were irradiated with three different radiation sources (neutron, gamma, and mixed gamma/neutron) in order to determine the independent effects that gamma and neutron radiation have on the fibers. The transmission spectra of the fibers were measured during each irradiation and the spectral shapes and attenuation were compared at similar doses. Comparisons of the spectra showed that gamma radiation results in increased attenuation over the 550-975 nm wavelengths. Fast neutrons were found to contribute to increased attenuation near 500 nm. Neutron radiation also caused up to twice the amount of radiation induced absorption that gamma radiation did over all wavelengths in the spectrum measured from 500-1100 nm at the same dose. The spectrum from 980-1100 nm was the same shape between the fast neutron and gamma-only irradiations. This indicates that a Co source could potentially be used to approximate the effects on the operating range of YDFs resulting from fast neutrons. A recovery prediction model was also applied and evaluated against actual recovery data. It was found to be unreliable as an accurate predictor of the initial (∼15 minutes) recovery of YDFs exposed to a dose rate of 65 krad(Si)/hr neutron and 9 Mrad(Si)/hr gamma. By adjusting one parameter in the model to account for the initial faster rate of recovery, the model was able to closely approximate the recovery of the fibers after longer irradiations out to longer recovery periods.

Experimental Investigation of Neutron Irradiation Effect on Silica-Based Erbium-Doped Fiber Amplifier

Experimental Study of the Temperature and Electron-Irradiation Effect on Erbium-Doped Fiber Amplifiers

Investigation of the Irradiation Effect on Erbium-Doped Fiber Amplifiers Composed by Different Density Erbium-Doped Fibers

Modeling and Experiments of the Gain and Noise Figure for an Irradiated Erbium-Ytterbium Co-Doped Fiber Amplifier

Experimental Investigation of Gamma Ray Radiation Effects on 1550nm Single Mode Fiber

Space radiation effect on the characters of fiber amplifiers for space optical communication

Experimental investigation of radiation effect on erbium-ytterbium co-doped fiber amplifier for space optical communication in low-dose radiation environment.

Space Radiation Effect on Edfa for Inter-Satellite Optical Communication

Influence of Pre-Radiation and Photo-Bleaching on the Yb-Doped Fiber Laser Radiated with Gamma-ray

Core Versus Cladding Effects of Proton Irradiation on Erbium-Doped Optical Fiber: Micro-Luminescence Study

Radiation Effect on EDFA for Inter-Satellite Optical Communication on Low Dose Orbits

Neutron versus Gamma Radiation Effects on Ytterbium-doped Optical Fibers

Temperature Influence on the Radiation Responses of Erbium‐Doped Fiber Amplifiers

Radiation-resistant cerium co-doped erbium-doped fibers for C- and L-band amplifiers in a high-dose gamma-radiation environment

Active Measuring Method for Investigating the Irradiation Effect on the Gain Characteristics of an Erbium-Doped Fiber Amplifier in Inter-Satellite Optical Communication

Gamma Radiation-Induced Effects over an Optical Fiber Laser: Towards New Sensing Applications

Analysis of the space radiation effect on EDFA for inter-satellite optical communication

Neutron Irradiation Effect on Amorphous Porous Silica

Irradiation-induced Effect Measurement in Double-clad Large Core Pure Quartz Fiber on 60 Co Source

LD End-Pumped Er,Pr:GYSGG Single Crystal Fiber Laser As a Potential Mid-Infrared Seed Source Applied in Radiation Environment

Ionizing Radiation Effect upon Er/Yb Co-Doped Fibre Made by In-Situ Nano Solution Doping