Abstract:Compressive strength is one of the most important properties of carbon fiber reinforced plastics (CFRP). In this study, a new method for predicting the axial compressive strength of CFRP using the response surface method is developed. We focused on a microbuckling model to predict the compressive strength of unidirectional fiber composites. For the microbuckling model, axial shear properties are required. To obtain the compressive strength for various material properties, we perform individual shear tests and numerical simulations, but these require enormous computational costs and extended time. To address the issue of computational cost, in this study, we propose a new method to predict compressive strength using the response surface method. First, we perform shear simulation in a microscale fracture model for unidirectional CFRP with various parameters of the fiber and resin properties. Based on the results of the shear simulation, the response surface method is used to evaluate and develop prediction equations for the shear properties. This method allows for the study of the objective values of the parameters, without significant computational effort. By comparing both the results predicted from the response surface method (RSM) and the simulation results, we verify the reliability of the prediction equation. As a result, the coefficient of determination was higher than 94%, and the validity of the prediction method for the compressive strength of CFRP using the response surface method (RSM) developed in this study was confirmed. Additionally, we discuss the material properties that affect the compressive strength of composites comprised of fibers and resin. As a result, we rank the parameters as follows: fiber content, elastic modulus after resin yield, yield stress, and initial elastic modulus.

Prediction of Long-Term Compression Strength for Quasi-Isotropic CFRP Laminates

Investigation on the Compressive Mechanical Properties of Ultra-Thick CFRP Laminates

Prediction of long-term fatigue life of CFRP composite hydrogen storage vessel based on micromechanics of failure

A 3D finite element model to simulate progressive damage in unidirectional- and woven-fibre thermoplastic discontinuous-long-fibre composites

Deformation and Fracture Mechanisms of Automated Fiber Placement Pre-Preg Laminates under Out-of-plane Tensile Loading

Weibull Distribution-Based Prediction Model for Compression after Impact (CAI) Strength of CFRP Laminates

Micromechanical modeling for longitudinal tensile property of unidirectional CFRP considering dispersion of fiber properties

Failure analysis and experimental study on bolted composite joints based on continuum damage mechanics

Failure Modes and Strength Prediction of Thin Ply CFRP Angle-Ply Laminates

Prediction of the Net-Tension Strength of Single Bolt Joint Using the 0° Ply Strength and Fracture Toughness

Enhanced Estimation of Axial Compressive Strength for CFRP Based on Microscale Numerical Simulation and the Response Surface Method

Collaborative Model in Brain-Computer Integration

Compressive Strength Determined for Ultrahigh Modulus Fiber Reinforced Composites by [90/0]ns Laminates

Experimental and numerical study on the tensile failure behavior of toughened-interlayer composite laminates with automated fiber placement (AFP) induced gap and overlap defects

Fatigue life prediction method of carbon fiber-reinforced composites

An investigation of Fatigue Behavior and Residual Strength Model of Steel-GFRP Composite Bar

Finite Element Analysis of Al-Carbon Fiber/Epoxy Composite Laminates

Tensile Performance Prediction of CFRPs with Voids Using Multiscale Analysis and Neural Networks

Parametric theoretical prediction of elastic properties and strength of fine weave pierced C/C composites

A Dynamic Constitutive Model and Simulation of Braided CFRP under High-Speed Tensile Loading

Progressive damage modelling and fatigue life prediction of Plain-weave composite laminates with Low-velocity impact damage