Abstract:Ideal cavities face a high risk of erosion in relation to pneumatic conveying. To reduce erosion, we introduce a height difference in the cavity, with the leading wall higher than the aft wall. To improve the cavity structure, the URANS (SST)-DPM method is adopted to study the effect of height difference h on gas flow, particle distribution, and particle erosion of a horizontal ideal cavity. The simulation procedure is validated by comparing the computational fluid dynamics results with experimental results. The results of the gas flow modeling show that the shear layer impinges on the aft wall when h is relatively small, and re-attaches on the downstream bottom wall as h increases. The re-attachment length is initially identical to the cavity width, then increases uniformly with h. Results of the particle distribution simulations indicate that for a Stokes number (St) of 0.12, the particles are evenly distributed in the cavity, and the distribution is independent of h; for St=1.2, dominated by the centrifugal force, the particles are mainly concentrated along the periphery of the main vortex when h is small. Owing to the variation of the main vortex, as h increases, more particles will fall down into the main vortex. For St=9.1, where gravity is dominant, the particles collide on the aft wall and rebound into the cavity through the main vortex when h is small. Otherwise, particles will move forward and only a few particles appear in the cavity. We explored the erosion distribution on the downstream bottom walls and extracted and analyzed the initial erosion positions. We also investigate the erosion on the aft walls, and the results indicate that lowering the aft wall even slightly will significantly reduce erosion.

Study on Hydraulic Characteristic of Aerator with Side-Walls Sudden Enlargement in Free-Flow Spillway Tunnel

Experimental Investigation of Flow Development in Large-Scale Bubble Columns in the Churn-Turbulent Regime

Model Test of Water Flow in Bend Chute of Spillway in Fenghuang Reservoir

Large Eddy Simulation of Hydraulic Characteristics after New Lateral Aerator

Investigation of Aerator Flow Pressure Fluctuation Using Detached Eddy Simulation with VOF Method

Experiment on Effect of Artificial Roughness on Water Flow Characteristic

Effects of air bubble quantity on the reduction of cavitation erosion

Effects of Non-Uniform Inflow on the Spatial and Temporal Distribution of Impeller Excitation in Axial Flow Pumps in Water Tunnels

Numerical Study of Solid Particle Erosion in a Cavity with Different Wall Heights

Numerical Simulation of Hydraulic Characteristics of Spillway Tunnel with Gradually Expanding Outlet and Lower outlet height

Experimental Research on Vertical Vortex in Spillway Tunnel Intake

Study on hydraulic characteristics of vertical pipe inlet/outlet of pumped storage plants

Experimental Study on the Principle of Oxygenation and Oxygenation Performance of Surface Blade Aerator

Experimental and numerical investigation on the cavitation erosion effect and resonance effect of submerged water jets

Experimental Investigation on the Cavity Evolution and Dynamics with Special Emphasis on the Development Stage of Ventilated Partial Cavitating Flow

Study on the internal two-phase flow of the inverted-umbrella aerator

Numerical Analysis of Cavitation Dynamics on Free Ogee Spillways Using the Volume of Fluid (VOF) Method

Self-aeration on large dam spillways during major floods

Study on flow characteristic of Carrousel oxidation ditch

The measurement design of vertical vortex in the spillway tunnel intake

3D Numerical Simulation and Experimental Analysis of Spillway Tunnel