Abstract:Planar steel plates have many advantages, including high precision, flexible outline shape fabrication, and convenient transportation and storage, which make them suitable for various steel structures (e.g., reticulated shell structures). However, the steel plates are not commonly used as structural members, because they have a relatively low out-of-plane flexural stiffness. To improve the flexural buckling resistance, a novel type of built-up plate member comprising two longitudinal plates is proposed in this study. Additionally, the flexural buckling behavior of the novel built-up members is investigated. A series of compression tests on 42 specimens of built-up plate members is conducted to determine the elastic and ultimate critical loads. Flexural buckling about the minor axis is observed to be the failure mode of the specimens. The equivalent slenderness ratio method is used to determine the theoretical elastic critical loads of the specimens. With consideration of the measured material properties, geometric imperfections, and residual stresses of the specimens, a refined finite-element model is developed to simulate the flexural buckling behavior. Furthermore, the applicability of two representative specifications (American and European) to the novel built-up member is discussed. The results indicate that the design strengths calculated using these specifications are generally conservative for determining the ultimate loads of the built-up plate members. Design curve “c” in Eurocode 3 is found to be the most suitable among the specifications of interest for determining the design strength. This study provides valuable guidance for the design of built-up plate members.

Experimental Investigations for Compression-Flexure Characters of Laminated Box Beam Columns

The Flexural Behavior of Cross Laminated Bamboo and Timber (CLBT) and Cross Laminated Timber (CLT) Beams

Experimental Investigation into Flexural Buckling of Double-Limb Built-Up Plate Members under Compression

Investigation on the Compressive Mechanical Properties of Ultra-Thick CFRP Laminates

Experimental Studies on Glubam Columns under Axial Compression

Numerical Analysis for Geometry Nonlinear Characters of Laminated Box Beam Columns

EXPERIMENTAL STUDIES OF GLUBAM COLUMNS UNDER AXIAL LOADS

Experimental Investigations of Shear Lag Effect in a Simply Supported [0o ∕±45o2 ∕ 0o]t Laminated Box Beam

Flexural Behavior of Hybrid Composite Beams with a Bamboo Layer and Lattice Ribs

Behavior of Preloaded RC Beams Strengthened with CFRP Laminates

Study on Flexural Stiffness of Frame Composite Slim Beam with Deep Deck

Experimental Study on Flexural Behavior of Frame Composite Slim Beam with Deep Deck

The Flexural Behaviour of Composite Sandwich Beams with a Lattice-Web Reinforced Wood Core

Flexural Performance of Sandwich Beams with Lattice Ribs and a Functionally Multilayered Foam Core

Flexural performance test of carbon fiber reinforced composite sandwich beams with cedarwood core

EXPERIMENTAL STUDY ON FLEXIONAL BEHAVIOR OF TIMBER BEAM STRENGTHENED WITH FRP

Loading capacity of composite slim frame beams

Experimental Investigation on Axial Compressive Behavior of Frp Confined Concrete Columns

Compression and Bending Performances of Carbon Fiber Reinforced Lattice-Core Sandwich Composites

Experimental Investigation on Deformation and Strength of Carbon/epoxy Laminated Curved Beams