Abstract:Supported V2O5–WO3/TiO2 materials are employed as selective catalytic reduction (SCR) catalysts for NOx emission control from power plants. Fresh SCR catalysts usually receive exposure to harsh treatments in the industry to accelerate catalyst activation (calcination in air at 650 °C) and catalyst aging (hydrothermal aging at 650 °C) in a way that represents various points in the catalyst/product lifetime. The present study investigates the catalyst structural and chemical changes occurring during such harsh treatments. Three series of supported V2O5–WO3/TiO2 catalysts were prepared by incipient-wetness impregnation of aqueous ammonium metavanadate and metatungstate precursors. The catalysts were subsequently dried and calcined at 550 °C in O2, 650 °C in O2, and hydrothermal conditions (10% O2, 8% H2O, 7% CO2, and 75% N2) at 650 °C. The resulting catalysts were physically characterized by numerous techniques (in situ Raman; in situ IR; in situ high-field–high-spinning solid-state 51V MAS NMR; in situ electron paramagnetic resonance; X-ray diffraction; Brunauer, Emmett, and Teller surface area; and inductively coupled plasma) and chemically probed with adsorbed ammonia, SCR–TPSR, and the SCR reaction. The surface WOx sites on the TiO2 support behave as a textural promoter that stabilizes the TiO2 (anatase) phase from sintering and transforming to the undesirable crystalline TiO2 (rutile) phase that can lead to formation of a Ti1–xVxO2 (rutile) solid solution with reduced V4+ cations (∼7–15%). The surface VOx sites are mostly oligomerized as surface V5+Ox sites (∼50–85% oligomers) and the extent of oligomerization tends to increase with surface WOx coverage and calcination temperature. A major difference between the calcined and hydrothermally treated catalysts was the low concentration of surface NH3* species on Lewis acid sites for the hydrothermally treated catalysts, yet the SCR activity was almost comparable for both catalysts. This finding suggests that surface NH4+*, primarily associated with the surface VOx sites, are able to efficiently perform the SCR reaction. Given that multiple catalyst parameters were simultaneously varying during these treatments, it was difficult to correlate the SCR activity with any single catalyst parameter. A correlation, however, was found between the SCR TOF/activity and the sum of the surface NH3* and NH4+* species, which is dominated by the surface NH4+* species.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acscatal.1c02130.ICP of vanadium content of catalysts; crystallite sizes for supported VWTi catalysts treated at 650 °C; EPR determination of V4+; solid-state 51V MAS NMR spectra of dehydrated supported V2O5–WO3/TiO2 catalysts calcined at 650 °C; EPR spectra of non-vanadium species; in situ TP-IR spectra of surface ammonia species during SCR; correlation plots between steady-state SCR TOF values and structural properties of VWTi catalysts; and radar plots of catalytic activity and catalyst properties (PDF)This article has not yet been cited by other publications.

Effect of Cordierite-Modified on SCR Commercial Catalyst

Effects of Cordierite on V_2O_5-WO_3/TiO_2 Catalytic Performance

Enhancement of SCR Activity and Mechanical Stability on Cordierite Supported V2O5-WO3/TiO2 Catalyst by Substrate Acid Pretreatment and Addition of Silica

Tungsten Oxide Modified V2O5-Sb2O3/TiO2 Monolithic Catalyst: NH3-SCR Activity and Sulfur Resistance

Effects of Silica Additive on the NH 3 -SCR Activity and Thermal Stability of a V 2 O 5 /WO 3 -Tio 2 Catalyst

In-situ Synthesis of Monolithic Cu-Mn-Ce/cordierite Catalysts Towards VOCs Combustion

The Effect of Calcination Temperature on the Structure and Activity of TiO2/SiO2 Composite Catalysts Derived from Titanium Sulfate and Fly Ash Acid Sludge

Influence of texture structures of TiO2 supports on surface properties and SCR performance of V2 O5-MoO3/TiO2 catalyst

Catalytic oxidation of CO over V2O5/TiO2 and V2O5-WO3/TiO2 catalysts: A DFT study

[Effect of Vanadium and Tungsten Loadings on the Surface Characteristics and Catalytic Activities of V2O5-WO3/TiO2 Catalysts].

Promotion Effect of Tungsten Oxide on SCR of NO with NH3 for the V2O5–WO3/Ti0.5Sn0.5O2 Catalyst: Experiments Combined with DFT Calculations

Enhancement of low-temperature NH3-SCR catalytic activity and H2O & SO2 resistance over commercial V2O5-MoO3/TiO2 catalyst by high shear-induced doping of expanded graphite

The Effects of Tungsten and Hydrothermal Aging in Promoting NH3-SCR Activity on V2O5/WO3-TiO2 Catalysts

Promotional Effect of Ce-Doped V2o5-Wo3/Tio2 with Low Vanadium Loadings for Selective Catalytic Reduction of Nox by Nh3

Highly Efficient Mesoporous V2O5/WO3–TiO2 Catalyst for Selective Catalytic Reduction of NOx: Effect of the Valence of V on the Catalytic Performance

Influence of Preparation Conditions on Pore Structure and Activity of V2O5-WO3/TiO2 Honeycomb Catalysts

Dispersion of Tungsten Oxide on SCR Performance of V2O5WO3/TiO2: Acidity, Surface Species and Catalytic Activity

Effect of Synthesis Methods on Activity of V2O5/CeO2/WO3-TiO2 Catalyst for Selective Catalytic Reduction of NOx with NH3

Effect of Catalyst Crystallinity on V-Based Selective Catalytic Reduction with Ammonia

Performance of Ce-modified V-W-Ti type catalyst on simultaneous control of NO and typical VOCS

Structure–Activity Relationships of Hydrothermally Aged Titania-Supported Vanadium–Tungsten Oxide Catalysts for SCR of NO x Emissions with NH 3