Abstract:With the demand of lightweight vehicle structures, resistance spot welding of multi-stackup steel sheets is increasingly applied in some complex structures such as front longitudinal rails, A, B, and C pillars, and the bulkhead to inner wing. However, due to the difference in mechanical and physical properties for different sheet grade, the contacts of the workpieces and resultant weld current flow are complex in welding process. As a result of this, the weld nugget sizes at the faying interfaces become an issue. Therefore, it is essential to obtain an understanding of the welding process [1]. In this study, a combined thermal-mechanical/thermalelectrical incremental model has been developed to reasonably predict the nugget formation in resistance spot welding process. These calculations would provide guidance in the selection of welding variables for resistance spot welding of multi-stackup assemblies. 2. Numerical Modeling Figure 1 shows an example of multi-stackup steel sheets with various sheet gages and material properties. Galvanized coated low carbon steel (SAE1004) and high strength steel (DP600) was used in this study. A weld nugget will develop first at the sheet-to-sheet interface, and then in an increasing volume of material about the sheet-tosheet interface. At the completion of weld cycle, the current is shut off and the hold cycle begins. The water-cooled copper electrodes extract a significant quantity of heat from the weld area. Because the electrodes are in contact with sheets, the weld region is effectively quenched. Finally, the electrodes are retracted and a completed weld is developed.

Prediction Control Method of Spot Welded Nugget Size Based on Finite Element Analysis of Thermo-Electricity Transient

Modeling and Experimental Research on Resistance Spot Welded Joints for Dual-Phase Steel

Prediction of Double-Sided Arc Welding Deformation Based on Dynamic Heat Distribution Model and TEP-FE Approach

Numerical Prediction and Control of Deformation and Residual Stress in Double-Sided Arc Welding of Large Pressure Hull

Numerical Simulation of Nugget Formation in Resistance Spot Welding of DP590 Dual-phase Steel

Modeling and Process Analysis of Resistance Spot Welded DP600 Joints Based on Regression Analysis

Numerical analysis of the thermo-electric transient process during DP600 dual-phase steel resistance spot welding

Control method for nugget size of resistance spot welding of three-layer steels with different thickness and strength

Visualization of Nugget Formation in Resistance Spot Welding of Multi-Stackup Sheets

Numerical Simulation on Deformation and Stress Variation in Resistance Spot Welding of Dual-Phase Steel

Nugget Shifting in Resistance Spot Welding of Multi-Stackup Sheets

Simulating Thermoelectric Effect and Its Impact on Asymmetric Weld Nugget Growth in Aluminum Resistance Spot Welding

Study on the Thermo-Effect of Nugget Growing in Single-Phase AC Resistance Spot Welding Based on the Calculation of Dynamic Resistance

Modeling of resistance spot welding of multiple stacks of steel sheets

Numerical simulation of resistance spot welding considering phase transition effect

Multi-field Dynamic Modeling and Numerical Simulation of Aluminum Alloy Resistance Spot Welding

FINITE ELEMENT SIMULATION OF NUCLEATION PROCESS DURING RESISTANCE SPOT SINGLE-SIDED WELDING TUBESHEET

Interfacial Fracture of Resistance Spot Welding of Dual-Phase Steel

Finite Element Analysis for Transient Thermal Characteristics of Resistance Spot Welding Process with Three Sheets Assemblies

Study on the Thermal Expansion Displacement During Spot Welding Depending on the Multi-Physical Coupling Finite Element Model

Critical Specimen Thickness of Hot Galvanized Dual-Phase Steel Spot Welding