Abstract:Internal metallurgical defects and poor mechanical properties and surface quality of the formed parts are the most important challenges of metal micro-droplets deposition manufacturing technology. Lack of strong coalescence between neighboring droplets and the blocking effects of periodic ripples on the fusion process are major sources of abovementioned problems. To address this issue, a tungsten inert gas (TIG) welding arc was introduced to pre-melt the material below the droplet impacting location, thus, one droplet train will be deposited on a curved molten pool surface to fabricate deposited layers in an additive approach. In the present work, a numerical model based on the computational fluid dynamics (CFD) method was developed to investigate the dynamic behaviors of successive droplets' impact and coalescence on the molten pool created by a tilted TIG welding arc, and focuses on the effect of the offset distance between the impacting point of droplet and the longitudinal plane of molten pool on the deposition morphology and the impact-induced molten pool behaviors. The simulated tracks exhibit regular scaly shapes at different offset distances, which is validated against the corresponding experiments. The results indicated that as the lateral offset distance increases, the symmetric spreading and recoiling of the subsequent droplets on the pre-existing bead will be broken due to the inclined and curved solidification front morphologies, the inclined front morphologies are caused by the increased growth rate of the solidification front at the impact zone. With an increased lateral offset distance, the volume of the molten pool decreases, the width of the rear molten pool increases slightly. The calculated solidification parameters are found to be dependent of the offset distance, and vary significantly at the onset of solidification at different portions of the molten pool. The scientific findings provide useful insights for further researches of TIGassisted DDM.

Thermal Accumulation in Metal Micro-Parts Fabricated by Micro Droplet Deposition Manufacturing Technique

Investigation of the thermal behavior during the direct writing metal additive manufacturing

Manufacturing of micro thin-walled metal parts by micro-droplet deposition

Research on the temperature control strategy of thin-wall parts fabricated by laser direct metal deposition

Microchannels Formed Using Metal Microdroplets

NUMERICAL SIMULATION OF PILEUP PROCESS IN METAL MICRODROPLET DEPOSITION MANUFACTURE

Influence of Droplet Size and Ejection Frequency on Molten Pool Dynamics and Deposition Morphology in TIG-aided Droplet Deposition Manufacturing

Numerical Investigation of Pileup Process in Metal Microdroplet Deposition Manufacture.

Numerical Simulation and Validation of Metal Micro-droplet Deposition Forming

Numerical analysis of pileup process in metal microdroplet deposition manufacture

Modeling of Temperature Field Evolution During Multilayered Direct Laser Metal Deposition

Uncovering Microstructure Evolution and Dynamic Softening Mechanism of Spray-Deposited AlZnMgCu Alloy Under Thermal Deformation

Thermal Analysis and Verification for Direct Metal Deposition of 0Cr18Ni9 Stainless Steel

Numerical Investigation of Thermocapillary-Induced Deposited Shape in Fused-Coating Additive Manufacturing Process of Aluminum Alloy

Offset impacting of a liquid aluminum droplet train on a molten pool on a horizontally moving substrate during TIG-assisted droplet deposition manufacturing

Numerical Analysis of Particulate Migration Behavior Within Molten Pool During TIG-Assisted Droplet Deposition Manufacturing of SiC Particle-Reinforced Aluminum Matrix Composites.

Investigation of Droplet Transfer Behaviours in Cold Metal Transfer (CMT) Process on Welding Ti-6Al-4V Alloy

Micro-extrusion process and microstructure evolution of miniature heat pipe in 6063 aluminum alloy

Microstructure characteristics under varying solidification parameters in different zones during CMT arc additive manufacturing process of 2319 aluminum alloy

Exploring impact, spreading, and bonding dynamics in molten metal deposition for novel Drop-on-Demand printing

Numerical and Experimental Investigation of Molten Metal Droplet Deposition Applied to Rapid Prototyping