Abstract:Too low humidification levels and too high stack temperatures, insufficient reactant gas flows causing starvation phenomena, bad controls of pressure gaps between anode and cathode, further mechanical stress in the electrolyte can lead to severe and irreversible damages in PEM fuel cells, i.e., sealing and gasket deterioration, and/or break in the membranes. Overboard leak checks, sometimes called pressure tests, performed with nitrogen and air are usually employed to highlight gas leakages inside the stack between anode and cathode stack compartments. This procedure allows perfectly well the detection of crossover leaks occurring within the stack assembly. However, it is not appropriate to locate which cell or cells have failed, to inform actually where the fault has occurred. The actual need of diagnosis procedures meeting these requirements is important. Indeed, once the failed cells are identified, they may be removed and replaced by safe ones. The article presents some data and descriptions of two failed fuel cell stacks with different power levels, namely 100W and 5kW. Some leak checks are first performed and then some experimental investigations are carried out with the goal to locate the defective cells. Some electrical signals which reflect the faults are generated. The open current voltages of the cells are monitored in different operating conditions linked with the gas supply (flow rates, pressures). The procedures allow the detection of the failed cells, which show abnormal performance and voltage pattern when compared to the other cells in the stack. The tests are also conducted in conditions that preserve as much as possible the integrity of the other safe cells. The experimental analysis is supported by the proposition of modelling actions.

The Fault Analysis and Diagnosis of Proton Exchange Membrane Fuel Cell Stack

Early Fault Diagnosis Approach for PEM Stack based on Phase Measurement of Single-Frequency Impedance

Diagnosis Methods Dedicated to the Localisation of Failed Cells Within PEMFC Stacks

Fault Diagnosis Review of Proton Exchange Membrane Fuel Cell Systems: Fault Mechanisms, Detection and Identification, and Fault Mitigation

Design of a Fuel Cell Test System with Fault Identification

Data-Driven Fault Diagnosis Method for PEMFC Based on NCA-KNN

Recent advances and summarization of fault diagnosis techniques for proton exchange membrane fuel cell systems: A critical overview

Fault Diagnosis for Proton Exchange Membrane Fuel Cell Systems Via Improved Equivalent Circuit Model and Multiple Support Vector Machines

A Multi-Stage Fault Diagnosis Method for Proton Exchange Membrane Fuel Cell Based on Support Vector Machine with Binary Tree

A double-fuzzy diagnostic methodology dedicated to online fault diagnosis of proton exchange membrane fuel cell stacks

Health Management for PEM Fuel Cells Based on an Active Fault Tolerant Control Strategy

A review of fault diagnosis and fault-tolerant control of vehicular polymer electrolyte membrane fuel cell power system

A double-fuzzy diagnostic methodology dedicated to online fault diagnosis of PEMFC stacks

A Fuzzy Logic-based Method for Proton Exchange Membrane Fuel Cell Fault Diagnosis

A health management review of proton exchange membrane fuel cell for electric vehicles: Failure mechanisms, diagnosis techniques and mitigation measures

Performance degradation and process engineering of the 10 kW proton exchange membrane fuel cell stack

Investigation of the assembly for high-power proton exchange membrane fuel cell stacks through an efficient equivalent model

Review on proton exchange membrane fuel cell stack assembly: Quality evaluation, assembly method, contact behavior and process design

Micro-current Excitation for Efficient Diagnosis of Membrane Electrode Assemblies in Fuel Cell Stacks: Error Analysis and Method Optimization

An Artificial Neural Network Ensemble Method for Fault Diagnosis of Proton Exchange Membrane Fuel Cell System

Durability degradation mechanism and consistency analysis for proton exchange membrane fuel cell stack