Abstract:The durability of proton exchange membrane (PEM) fuel cells is a key factor which prevents its commercial application on the vehicle. Dynamic current cycle is one of the most common conditions for PEM fuel cells, especially varying the currents between the idling and the rated condition. To investigate the degradation behavior of fuel cells under this kind of dynamic cycles, a PEM fuel cell stack with 330 cm2 active area is operated under 10,000 dynamic cycles with the cycling current density ranging from 25 mAcm−2 to 600 mAcm−2, which simulates common operating conditions in a vehicle cycle from the idling condition to the rated condition. Polarization curves, the high-frequency resistance (HFR), the uniformity of the individual cells, the performance degradation of PEM fuel cell stack at 25 mAcm−2 and 600 mAcm−2 are characterized to investigate the performance degradation over cycling. In addition, scanning electron microscopy (SEM) of the surface and the cross-section of the tested membrane electrode assemblies (MEAs) are compared with different single-cell samples. The results indicate that the degradation rate of the stack is 1.0 μVcycle−1 at 25 mAcm−2 under the idling condition. A more severe performance degradation of about 2.0 μVcycle−1 is detected at 600 mAcm−2 under the rated condition. The individual cell near the coolant outlet of the PEM fuel cell stack shows a more serious degradation caused by the HFR increase, which is also proved by the SEM analysis. The cross-section SEM analysis indicates that the dynamic cycle has a significantly negative effect on the catalyst layer, resulted in an obvious decrease on the thickness of the catalyst layer.

Performance degradation and process engineering of the 10 kW proton exchange membrane fuel cell stack

Degradation Analysis of the Core Components of Metal Plate Proton Exchange Membrane Fuel Cell Stack under Dynamic Load Cycles

Proton exchange membrane fuel cell degradation under close to open-circuit conditions

Degradation Differences of a Single Proton Exchange Membrane Fuel Cell: Energy Management Strategy and Dynamic Programming

Durability degradation mechanism and consistency analysis for proton exchange membrane fuel cell stack

Investigation of the reversible performance degradation mechanism of the PEMFC stack during long-term durability test

Experimental Study on the Effect of Flow Channel Parameters on the Durability of PEMFC Stack and Analysis of Hydrogen Crossover Mechanism

The Durability Investigation of a 10‐cell Metal Bipolar Plate Proton Exchange Membrane Fuel Cell Stack

Experimental Study of the Influence of Dynamic Load Cycle and Operating Parameters on the Durability of PEMFC

Degradation behavior of a proton exchange membrane fuel cell stack under dynamic cycles between idling and rated condition

Failure Behavior of Gas Diffusion Layer in Proton Exchange Membrane Fuel Cells

Failure of Cathode Gas Diffusion Layer in 1 Kw Fuel Cell Stack under New European Driving Cycle

Investigation of Dynamic Driving Cycle Effect on Performance Degradation and Micro-Structure Change of PEM Fuel Cell

Low Temperature Durability and Consistency Analysis of Proton Exchange Membrane Fuel Cell Stack Based on Comprehensive Characterizations

Rapid degradation characteristics of an air‐cooled PEMFC stack

Degradation Behavior of Membrane–electrode-Assembly Materials in 10-Cell PEMFC Stack

Thermodynamic and economic study of PEMFC stack considering degradation characteristic

Proton exchange membrane fuel cell degradation under close to open-circuit conditionsPart I: In situ diagnosis

Effect of driving cycle on the performance of PEM fuel cell and microstructure of membrane electrode assembly

Recovery characteristics of reversible degradation for proton exchange membrane fuel cell stack under accelerated stress test

Effect of load-cycling amplitude on performance degradation for proton exchange membrane fuel cell