Abstract:Preparation and tribological behaviors of the IR based tire treads. Abrasion and tribological properties of tread rubber play a crucial role in governing the service life of aviation tires and the safety of aircrafts. Polyisoprene (IR) with the same chemical structure as natural rubber shows great potential for application in aviation tires. Herein, the abrasion and tribological behaviors of IR based composites under sliding‐rolling conditions were investigated in relation to the carbon black (CB N234) content, sliding‐rolling ratio, ambient temperature, and counterparts in order to provide guidance for the development of high‐performance aviation tire treads. Moreover, the relationship between wear performances and physical–mechanical properties was discussed to establish a prediction model. The results revealed that physical and mechanical properties affected wear performances in a synergetic manner, which could be described as a negative linear correlation of the folding wear with the product of hardness and rebound resilience (H4R) and the ratio between rebound resilience and tensile strength ((1‐R)/σ) even at elevated temperature and sliding‐rolling ratio regardless of the counterpart. The increase in CB N234 content and sliding‐rolling (s‐r) ratio resulted in a transition of the wear mechanism from folding to abrasion due to the formation of soft rubber particles with a certain fluidity and a lubricating transfer film that was located at the friction interface and was generated by the thermal‐mechanical degradation of the IR matrix when it was rubbed against steel counterparts, which marred the aforementioned negative linear relationship. Highlights The increase in temperature improved the abrasion resistance of tire treads. The folding wear was negatively and linearly related to H4R and (1‐R)/σ. Increasing CB N234 content and s‐r ratio made a transition of wear mechanism.

The Influence of Tread Material Oil Aging on Tire Performance

Tread Rubber Material Oxidation Experiment and Influence on Tire Performance

Microscopic Analysis of Aging Effects on the Adhesion Properties Between Asphalt and Mineral Aggregate

Experimental Investigations on the Dynamic Mechanical Properties of Aged Rubbers

Influence of Thermal Aging in Oil on the Friction and Wear Properties of Nitrile Butadiene Rubber

Research on low temperature rheological behavior of aging resistant bitumen and mixture

Application of Low Mooney Viscosity Reclaimed Rubber in Passenger Car Tire Tread

Multilevel Analysis of the Aging Mechanisms and Performance Evolution of Rubber-Modified Asphalt

Effect Of Thermo-Oxidative Aging On Mechanical Properties And Tribological Behaviors Of Acrylonitrile-Butadiene Rubber

Truck Tire Thermal-Mechanical Fea and Dma with Application to Endurance Evaluation

Lifetime Prediction Of Tires With Regard To Oxidative Aging

Synergic effects of physio‐mechanical performances on sliding‐rolling tribological and abrasion behaviors of polyisoprene based aviation tire treads

Experimental investigation on the characteristics of tire wear particles under different non-vehicle operating parameters

Study on Wear Mechanisms for Automobile Tires

Experiment and Simulation Research on the Fatigue Wear of Aircraft Tire Tread Rubber

Influence Study of Oil Property Degradation on Engine Friction

Elucidation of smear wear layer structure and ageing mechanisms of filled tyre tread compounds

The Influence of Oil and Thermal Aging on the Sealing Characteristics of NBR Seals

The effect of aging in oil on the performance of a radial lip seal

Performance Deterioration Analysis of the Used Gear Oil

Shear Performance Optimizing Of Tire Shred-Sand Mixture