Abstract:To study the shear characteristics of rubber-sand mixtures, the effects of four rubber-sand mixtures gradations（one type of gap gradation, two types of continuous gradations, and one type of open gradation）, three rubber contents（10%, 30%, and 60%）, and three vertical stresses（30 kPa, 60 kPa, and 90 kPa） on the strength characteristics and volumetric change characteristics of rubber-sand mixtures were investigated by using a laboratory large-scale direct shear apparatus; and based on the laboratory direct shear test, the discrete element numerical models of pure sand and rubber-sand mixtures were established according to the same gradation and rubber content. The intrinsic mechanical mechanism of rubber-sand mixtures was explored from the perspective of particle contact state and displacement. The results show that the shear stress curve of rubber-sand mixtures is the same as that of pure sand at low rubber content, but its shear strength is lower than that of pure sand; the shear stress of rubber-sand mixtures increases with the increase of vertical stress, and the shear strength of continuous gradation SR2 is the highest among the four gradations of rubber-sand mixtures; the admixture of rubber particles can effectively inhibit the dilatancy of sandy soil, among which the gap grade SR1 has the best effect on inhibiting soil dilatancy, and the dilatancyis reduced by 37% compared with that of pure sand. The internal friction angle of rubber-sand mixtures decreases with the increase of rubber content, and the internal friction angle of continuous gradation SR2 is the largest under the same rubber content; rubber particles mainly participate in the formation of weak force chain in the rubber-sand mixtures force chain network, and the shear zone width of rubber-sand mixtures is smaller than that of pure sand.

Shear Performance Optimizing Of Tire Shred-Sand Mixture

Shear Behaviour of Sand-Rubber Mixtures: Interpretation from Energy Transformation and Force Chain Evolution

Micromechanical Investigation of the Shear Behaviors of Sand‒rubber Mixtures Using a Multibody Meshfree Method

Factors Affecting Strength and Stiffness of Dry Sand-Rubber Tire Shred Mixtures

Analysis on Anti-cracking Performance of High Viscoelastic Tar Sand

Micromechanical Discrete Element Modeling of Asphalt Mixture Shear Fatigue Performance

Engineering properties of tire shreds reinforced soils

Characterization of embankment material using sand tire mix as additive and validating the results obtained from large scale direct shear test in Abaqus software

FEM Analysis of Wasted Tire Chip and Sand as Construction Material for Piles

Effect of Rubber-Sand Mixtures Gradation on Shear Characteristics of Mixed Soil

Experimental Investigations on the Pull-Out Behavior of Tire Strips Reinforced Sands

Shear Strength Properties Of Waste Tires. Granulated Rubber And Loess Mixtures

Effect of Rubber-Sand Particle Size Ratio on Shear Properties of Rubber-Sand Mixtures under Normal Cyclic Loading

Effect of the particle size ratio on macro- and mesoscopic shear characteristics of the geogrid-reinforced rubber and sand mixture interface

A micromechanical investigation of sand–rubber mixtures using the discrete element method

Experimental Study on Dynamic Modulus and Damping Ratio of Rubber-Sand Mixtures over a Wide Strain Range

Facile strategies for green tire tread with enhanced filler-matrix interfacial interactions and dynamic mechanical properties

Effect of particle size and shape on shear strength of sand–rubber granule mixtures

Mechanical Behaviour of Completely Decomposed Granite Soil with Tire Rubber Granules and Fibres

Dynamic Properties of Clean Sand Modified with Granulated Rubber

Study on dynamic shear characteristics of calcareous sand reinforced with rubber and geogrid