Development of Transmission-Type Surface Plasmon Resonance Sensor Using A Two-Dimensional Nanobeads Array Structure

Akihito Korenaga,Hizuru Nakajima,Takashi Usui,Kazuhiro Morioka,Akihide Hemmi,Hulie Zeng,Shungo Kato,Katsumi Uchiyama

DOI: https://doi.org/10.2116/bunsekikagaku.63.1

2014-01-01

BUNSEKI KAGAKU

Abstract:A small amount of nanobeads suspension was dropped onto a partially polymerized PDMS/Glass plate. The nanobeads in the drop were self-assembled by a capillary force, accompanied by solvent evaporation. Subsequently, a three-dimensional (3D) nanobeads array structure was formed on the plate. The plate with a 3D nanobeads array structure was placed inside an ultrasound bath, and then the nanobeads outside the PDMS layer were removed, while the nanobeads lying on the PDMS layer remained. In this way, a two-dimensional (2D) nanobeads array structure was fabricated. The sensor chip for a transmission-type surface plasmon resonance (SPR) sensor was prepared by forming a thin layer of gold on the 2D nanobeads array structure, and then a novel transmission-type SPR sensor using the sensor chip was developed. The calibration curve for sucrose solutions obtained on the developed SPR sensor was linear for concentrations under 2000 mM with a correlation coefficient of 0.967. In contrast to the sensor chip with a nanohole array structure generally-used for a transmission-type SPR sensor, the developed sensor chip with the 2D nanobeads array structure has an advantage that the sensor chip can be easily prepared at low cost without the use of an expensive electron beam lithography system.