Investigation of Simultaneous Immunoassay by a Two-dimensional Surface Plasmon Resonance Sensor Using Multiplied Beam Splitting Optics
Kazuhiro Morioka,Hizuru Nakajima,Akihide Hemmi,Shinpei Iida,Fumi Kitamura,Hulie Zeng,Shungo Kato,Katsumi Uchiyama
DOI: https://doi.org/10.2116/bunsekikagaku.65.79
2016-01-01
BUNSEKI KAGAKU
Abstract:We have developed a two-dimensional surface plasmon resonance (SPR) sensor using multiplied beam-splitting optics. In this study, we evaluated immunoassays by the SPR sensor. As a result, we could measure the change of the reflected-light intensity in real time, which is based on the immobilization of an antibody onto the surface of the sensor chip, the adsorption of a blocking reagent onto the surface, and specific bonding of the antigen to the antibody immobilized on the sensor chip. The calibration curve for IgA was linear under a concentration of 6.0 mu g mL(-1), and a quantitative immunoassay was successfully accomplished by the SPR sensor. We also fabricated a sensor chip in which anti-IgA, anti-IgG and anti-IgM were immobilized on the detection point in the flow channel on the sensor chip, respectively. We then evaluated measurements of IgA, IgG and IgM using the sensor chip. When a sample solution containing IgA was introduced into the flow channel, the reflected light intensity at the detection point at which anti-IgA was immobilized dramatically increased, whereas the reflected light intensity at the detection point at which anti-IgG or anti-IgM was immobilized did not change. Similarly, in the case of IgG and IgM, the reflected light intensity only increased at the detection point at which corresponding antibody was immobilized. These results indicate that a simultaneous immunoassay by the SPR sensor should be possible.