Abstract:The unsteady behavior of a sweeping impinging jet is measured experimentally using time-resolved particle image velocimetry. For the configuration with a jet-to-wall spacing ratio L/dh = 8, an approximately linear increase in the sweeping frequency is observed with Reynolds numbers (Re) between 2.7 x 10(3) and 9.3 x 10(3), especially at high Reynolds numbers. The saturation of the sweeping jet, at which the maximum deflection angle is reached, occurs at Re = 6.7 x 10(3). Special focus is then placed on the spatial and temporal variations of unsteady flow fields at two Reynolds numbers Re = 4.0 x 10(3) and 9.3 x 10(3). The unsteady behavior in the near-exit region is first compared. At a higher Reynolds number, the jet in the near-exit region remains at the maximum deflection angle for a longer time during one oscillation cycle with more concentrated jet momentum, resulting in a faster switching process. In the near-wall region at Re = 4.0 x 10(3), the sweeping impinging jet exerts a large region of influence due to the oscillation motion of the impact region along the wall. The time-averaged velocity components and velocity fluctuating components near the wall show double peaks on both outer sides and a minimum in the middle of the near-wall region. At Re = 9.3 x 10(3), due to the rapid and intensive sweeping process, the jet column breaks in the near-exit region, resulting in a weak flow in the middle of the near-wall region. Accordingly, the profiles of the time-averaged velocity components and velocity fluctuating components show higher double-peak values but an even lower minimum value. Finally, the state-of-the-art dynamic mode decomposition method is used to capture the main flow behavior of distinct frequencies at these two selected Reynolds numbers. Bounded by the breaking location of the jet column, the flow with a superharmonic oscillation frequency in the middle of the near-wall region disappears at Re = 9 x 10(3). Therefore, the energetic flow patterns are found to be more evenly distributed in the near-exit region than in near-wall region. The phase correlation between the captured flow patterns is determined by projecting the phase-averaged flow fields onto the most energetic modes.

Experimental Study of Oscillation Behaviors in Confined Impinging Jets Reactor under Excitation

Experimental Study of Flow Regimes in Three‐dimensional Confined Impinging Jets Reactor

Experimental Study on Oscillation Behaviors in T-Jets Reactor with Excitation

Mixing characteristics and enhancement of excitation in mini confined impinging jets reactor

Numerical Simulation of the Performance of the Sc-89 Jet Impact System

Numerical Simulation of Viscous Flow Past an Oscillating Square Cylinder Using A Cip-Based Model

Experimental study of oscillation of axisymmetric turbulent opposed jets with modulated airflow

Poiseuille Flow-Induced Vibrations of a Cylinder in Subcritical Conditions

Experimental Study about Mixing Characteristic and Enhancement of T-jet Reactor

Experimental investigation of deflecting oscillation in T-jets reactor

Experimental Study Of Planar Opposed Jets With Acoustic Excitation

Experimental Investigation of Flow Regimes of Axisymmetric and Planar Opposed Jets

Experimental and Numerical Studies on Flow and Turbulence Characteristics of Impinging Stream Reactors with Dynamic Inlet Velocity Variation

Experimental Investigation of Flow Dynamics of Sweeping Jets Impinging Upon Confined Concave Surfaces

Effect of Suction and Discharge Conditions on the Unsteady Flow Phenomena of Axial-Flow Reactor Coolant Pump

Investigation of three-dimensional flow regime and mixing characteristic in T-jet reactor

Flow regimes and mixing characteristics in non-aligned T-jets reactors

Interaction of dual sweeping impinging jets at different Reynolds numbers

The initial flow structures and oscillations of an underexpanded impinging jet

Unsteady Behavior of a Sweeping Impinging Jet: Time-resolved Particle Image Velocimetry Measurements

Oscillations in Rectangular Supersonic Inlets with Large Internal Contraction Ratio