Abstract:Planar parabolic refractive lenses are one important kind of compound refractive lenses which are used in the third generation synchrotron radiation sources as an x-ray focusing device. In order to test the influence of the number of the individual lens on the transmission and gain, a set of 30 micro-focusing planar parabolic lenses with different number (from 1 to 30) of the individual lens was designed, which had equal apertures of 250 μm and equal focal length of 30 cm at 8.05 keV. The parameters of the lenses were optimized for performing focusing test at x-ray diffractometer (XRD). The optical simulation was completed by ray tracing by the commercial program of ZEMAX. The radius of curvature at the tip of the parabola ranged from 1.23 μ to 37 μ and the theoretical transmission from 43.3 % to 33.2 %. The theoretical width of focal line was about 3.4 μ. Ultra violet lithography was used to fabricate the planar lenses from SU-8 photoresist which thickness was 224 μ. Measured dimension of lenses is coincident with the theoretical one. Focusing properties of the lenses were studied both at XRD and at U7B beamline at the National Synchrotron Radiation Laboratory (NSRL) at the energy of 8.05 keV. The detector was a Peltier-cooled, 1380 × 1030 format (6.45 ×x 6.45 μ2 pixels) charge coupled device with a fiber-optic-coupled scintillator (Photonic Sciences Ltd., "X-ray Fast Digital Imager"). The width of focal line was about 27.4 μwith a gain of 7.17 for N=8 lenses which was achieved in the NSRL. The reasons for the big difference between theoretical values and measured ones were discussed. ©2009 SPIE.

Combined Optic System Based on Polycapillary X-ray Optics and Single-Bounce Monocapillary Optics for Focusing X-rays from a Conventional Laboratory X-ray Source

13.1 micrometers hard X-ray focusing by a new type monocapillary X-ray optic designed for common laboratory X-ray source

Quasi-parallel X-ray microbeam obtained using a combined system of polycapillary optics

Monochromatic X-ray Imaging Using a Combination of Doubly Curved Crystal and Polycapillary X-ray Lens.

Application Of A Combined System Of Polycapillary X-Ray Lens And Toroidal Mirror In Micro-X-Ray-Absorption Fine-Structure Facility

Application of Monolithic Polycapillary X-Ray Lens in Focusing of Synchrotron Radiation

Focusing Synchrotron Radiation Using a Polycapillary Half-Focusing X-ray Lens for Imaging.

An X-ray Focusing Monochromator Composed of Poly-Capillary X-ray Lenses and Highly Oriented Pyrolytic Graphite

Polycapillary X-ray Lens for the Secondary Focusing Beijing Synchrotron Radiation Source

Numerical design of in-line X-ray phase-contrast imaging based on ellipsoidal single-bounce monocapillary

Development of a New X-ray Scattering Instrument Based on Two Polycapillary X-ray Optics

An Energy Dispersive Micro X-ray Diffractometer Based on a Combined System of Polycapillary Optics

Focusing of hard x-rays with SU-8 resist planar parabolic refractive lenses

Numerical design and characterization of a novel parallel beam combined lens based on X-ray capillary optics

Performances of Synchrotron Radiation Microbeam Focused by Monolithic Half Focusing Polycapillary X-Ray Lens

Numerical design of polycapillary X-ray optics as both a focusing X-ray lens and a vacuum window

Determination of Parameters of X-ray Source Based on Single-Bounce Ellipsoidal Monocapillary X-ray Condenser

Performances for confocal X-ray diffraction technology based on polycapillary slightly focusing X-ray optics

Optimization of Focusing Structure for a Micro-Focus X-ray Source

Quasi-parallel X-ray microbeam obtained using a parabolic monocapillary X-ray lens with an embedded square-shaped lead occluder

X-ray Lens of Monolithic Polycapillaries for Macromolecular Crystallography.