Abstract:Fuel injection is one of the most important processes in compression-ignition internal combustion engines owing to its significant impact on the exhaust emissions and thermal efficiency. In this study, experiments were carried out to investigate the influence of injection pressure and injection timing on the temporal evolution of the injection rate and injection duration in a specially designed experiment rig equipped with a common rail injection system. It is well known that the injection signal from the electronic control unit (ECU) of the injection system, which is often the only injection information available in engine operation and experiments, gives little information about the actual injection rate profile. It is shown in the present experiments that the actual injection duration is usually longer than the energizing time (ET). The time delay between the actual injection of the fuel and the ECU signal is about 0.3-0.4 ms, and the time delay appears to be insensitive to the injector geometry and injection pressure condition. The injection process can be characterized as five stages, a fast injector valve opening stage, a slow valve opening stage, a valve fully open stage, followed by a slow valve closing stage, and finally a rapid valve closing stage. It is found that the first stage, the fast valve opening stage, is insensitive to the injection pressure and injector nozzle diameter; however, the peak injection rate is a strong function of these parameters. The second and the third stage may not appear with a short injection duration. A new injection model was developed for the common rail injection system, which was capable of simulating the instantaneous fuel injection rate and injection duration for a range of injection pressure and injection duration. The model was shown to be able to replicate the experimental injection rate profile of the present experiments and experiments found in the literature for common rail injection system. The new injection model was applied to predict the effect of injection pressure and injection duration on the performance of a diesel engine under various engine speed and load conditions. The new injection model was shown to be able to describe the injection mass flow rate, which eventually leads to a reasonably good prediction of the variations of the spray development, in-cylinder pressure, heat release rate, and emissions.

Start-of-injection-based software optimization for consistency between the cylinders in common-rail diesel engines

Experiment-Based Software Optimization for Cylinders Consistency in Electronic Unit Pump Diesel Engines

A Kind of Common-Rail Electronical Controlled Diesel Fuel Injection System

Experimental study and optimization in the layouts and the structure of the high-pressure common-rail fuel injection system for a marine diesel engine

Common rail injection system on-line parameter calibration for precise injection quantity control

An Innovative Rail Pressure Sensor Signal Processing Algorithm to Determine the Start of Injection and End of Injection of Diesel Engines With Common Rail Injection Systems.

An Experimental Study on the Inconsistency Correction of Cycle Fuel Injection Quantity for Electronic Unit Pump

Simulation of the Effect of Fuel Injection Rate that Matches Fuel Injection Advanced Angle on the Performance of Ultra High Pressure Common Rail Diesel Engine

Research on Fuel Injection Strategy of Start Process for the Electronic Diesel Engine

Experimental and Modeling Study of Liquid Fuel Injection and Combustion in Diesel Engines with a Common Rail Injection System

Research on Fuel Offset Control of High-Pressure Common-Rail Diesel Engine Based on Crankshaft Segment Signals

Effect of Common Rail System on Vehicle Engine Combustion Performance

On the Fuel Injection Rate Profile As Boundary Conditions for Diesel Spray Combustion Simulations

Numerical Simulation of Common Rail Fuel Injection System Fueled with Dimethyl Ether

Research on Control Strategy for Improving Cylinder Consistency of Diesel Engine

A Virtual Calibration Method Based on Diesel Engine Simulation Model

A study on cycle fuel injection quantity variation for a diesel engine combination electronic unit pump system

Development of Electronically Controlled Common Rail Fuel Injection System for Diesel Engine

Influence of change of common-rail and high-pressure fuel pipe parameters in electric control system of diesel engine on system performance

Improvements on the start performance of diesel engine by fuel control strategy optimization and heating measures

Development and Bench-Testing of A Common Rail System for Dimethyl Ether