Abstract:Fuel injection is one of the most important processes in compression-ignition internal combustion engines owing to its significant impact on the exhaust emissions and thermal efficiency. In this study, experiments were carried out to investigate the influence of injection pressure and injection timing on the temporal evolution of the injection rate and injection duration in a specially designed experiment rig equipped with a common rail injection system. It is well known that the injection signal from the electronic control unit (ECU) of the injection system, which is often the only injection information available in engine operation and experiments, gives little information about the actual injection rate profile. It is shown in the present experiments that the actual injection duration is usually longer than the energizing time (ET). The time delay between the actual injection of the fuel and the ECU signal is about 0.3-0.4 ms, and the time delay appears to be insensitive to the injector geometry and injection pressure condition. The injection process can be characterized as five stages, a fast injector valve opening stage, a slow valve opening stage, a valve fully open stage, followed by a slow valve closing stage, and finally a rapid valve closing stage. It is found that the first stage, the fast valve opening stage, is insensitive to the injection pressure and injector nozzle diameter; however, the peak injection rate is a strong function of these parameters. The second and the third stage may not appear with a short injection duration. A new injection model was developed for the common rail injection system, which was capable of simulating the instantaneous fuel injection rate and injection duration for a range of injection pressure and injection duration. The model was shown to be able to replicate the experimental injection rate profile of the present experiments and experiments found in the literature for common rail injection system. The new injection model was applied to predict the effect of injection pressure and injection duration on the performance of a diesel engine under various engine speed and load conditions. The new injection model was shown to be able to describe the injection mass flow rate, which eventually leads to a reasonably good prediction of the variations of the spray development, in-cylinder pressure, heat release rate, and emissions.

An Experimental Study on the Inconsistency Correction of Cycle Fuel Injection Quantity for Electronic Unit Pump

Accurate Measurement and Consistency Analysis of Fuel Delivery for Domestic Electronic Unit Pump

Experiment-Based Software Optimization for Cylinders Consistency in Electronic Unit Pump Diesel Engines

A study on cycle fuel injection quantity variation for a diesel engine combination electronic unit pump system

Research on Control Strategy for Improving Cylinder Consistency of Diesel Engine

Influence Factors Correlation Analysis on the Electronic Unit Pump Fuel Injection Quantity in Overall Operating Conditions

Quantitative Analysis on Cycle Fuel Injection Quantity Fluctuation of Diesel Engine Electronic In-line Pump System

Start-of-injection-based software optimization for consistency between the cylinders in common-rail diesel engines

Research on the Control Strategy of Fuel Injection System with Electronic Unit Pump

Analysis on Stability of Electron-Controlled Unit Pump System for Diesel Engine

Key Influence Factors Investigation on the Electronic Unit Pump Injection Characteristics

Numerical Investigation of the Fuel/Air Ratio Sensor Sensitivity in a Port-Fuel-Injected Spark-Ignition Engine Equipped with Three-Way Catalysts

Effects of Fuel Temperature on Injection Performance of an EUP System

Simulation and Measurement of Fuel Injection Quantity Based on TB4P

Common rail injection system iterative learning control based parameter calibration for accurate fuel injection quantity control

Simulation and Experiment of Electronic Unit Pump (EUP) System of Diesel Locomotive

Experimental Study on Injection Process of Electronically Controlled Common-rail Diesel Injection System

Simulation of the Effect of Fuel Injection Rate that Matches Fuel Injection Advanced Angle on the Performance of Ultra High Pressure Common Rail Diesel Engine

Quantitative Analysis on the Effects of Parameters of Electronic Injector on the Cycle Fuel Injection Quantity Fluctuation of High Pressure Common Rail System

Experimental and Modeling Study of Liquid Fuel Injection and Combustion in Diesel Engines with a Common Rail Injection System

Common rail injection system on-line parameter calibration for precise injection quantity control