Abstract:Fluid flow characteristics and particle motion behavior of an impinging stream reactor with dynamic inlet flow (both inlet velocity patterns exhibit step variation) are investigated and discussed with the computational fluid dynamics–discrete element method (CFD–DEM). The effect of T (variation period of the dynamic inlet flow) and ∆u (inlet velocity difference) on the motion characteristics of single and multiple particles, as well as the mean particle residence time, are studied and discussed. The research results indicate that, compared with the traditional impinging stream reactor (both inlet velocities are equal and constant) with equal mean inlet velocity (um) within one period, the impinging surface is instantaneously moving and the flow regime is varied with time in the impinging stream reactor with dynamic inlet flow. The impinging stream reactor with dynamic inlet flow provides higher cost performance over the traditional impinging stream reactor, under equal um, in terms of single-particle residence time. Moreover, three new particle motion modes exist in multi-particle motions of the impinging stream reactor with dynamic inlet flow; particles are accelerated by the original or reverse fluid and perform oscillatory motion at least once after an interparticle collision. Whether it is a single particle or multi-particles, the mean particle residence time reaches a maximum value when T/2 is approximately equal to the first particle acceleration time, since the maximum axial kinetic energy increases in every oscillatory motion compared with traditional impinging stream, and the number of oscillatory motions is increasing. The mean residence time of a particle in the impinging stream reactor with a dynamic inlet flow increases with increasing ∆u, since the dynamic inlet conditions and increasing ∆u can continuously supply more energy to particles and thus cause more particles to enter one of the three new modes of particle motion.

Analysis of gas-particle flow characteristics in impinging streams

Research on motion characteristics of gas-solid jet flow

Modeling and numerical simulation of gas-solid jet in the transitional-rarefied regime

Numerical Simulation of Gas-Particle Two-Phase Flow in Impinging Streams Gasifier

Penetration, accumulation, and swing characteristics of particle cloud in a turbulent axisymmetric opposed-jet flow

Experimental and Numerical Analyses of Gas–solid-Multiphase Jet in Cross-Flow

Quadrature Method of Moments for Nanoparticle Coagulation and Diffusion in the Planar Impinging Jet Flow

Numerical study of particle behavior in laminar axisymmetric opposed-jet flows

Simulation of Droplet-gas Flow in the Effervescent Atomization Spray with an Impinging Plate

Direct Numerical Simulation of a Three-Dimensional Particle Laden Plane Mixing Layer Considering Inter-Particle Collisions

Experiment and Simulation for Gas-particle in Cubic Duct with Jet Flow

Four-way coupled modelling of swirling particle-laden flow in Methane-central coaxial jets

3D Numerical Study of Particle Flow Behavior in the Impinging Zone of an Opposed Multi-Burner Gasifier

Hydrodynamic Modeling of Turbulence Modulation by Particles in Swirling Gas-Particle Two-Phase Flow

NUMERICAL SIMULATION OF LAMINAR SQUARE IMPINGING JET FLOWS

A Comparison of Two-Fluid Model, Dense Discrete Particle Model and CFD-DEM Method for Modeling Impinging Gas–solid Flows

Three-Dimensional Simulation of Turbulent Rectangular and Square Impinging Jet Flows

Hydrodynamic Modeling of Turbulence Modulation by Particles in a Swirling Gas–Particle Two-Phase Flow

Numerical Simulations of a Gas–Solid Two-Phase Impinging Stream Reactor with Dynamic Inlet Flow

Distribution of Particle Resident Time in a Combined Coaxial Gas–solid Two-Phase Impinging Stream

Simulation of Sudden-Expansion and Swirling Gas-Particle Flows Using A Two-Fluid Particle-Wall Collision Model with Consideration of the Wall Roughness