Abstract:A new nondestructive pressure-measurement method that can avoid potential safety problems caused by applying traditional pressure-measurement methods in vessels is presented. This method utilizes ultrasonic Rayleigh waves and critically refracted longitudinal waves ( L CR waves). The change in pressure induces a change in the stresses in the vessel's wall. According to the acoustoelastic principle, variations in stress affect the wave velocity. Meanwhile, the velocity of ultrasonic waves can also be affected by the change in temperature. Considering the effect of the pressure and temperature of the vessel on both the wave velocity and propagation distance of the ultrasonic waves, the relationship between ultrasonic transit time delay and both the pressure and temperature change is established. Furthermore, a modified model of pressure measurement is deduced. With this model, a reference method for temperature compensation, without temperature measurement, is presented. The reference method utilizes Rayleigh waves and L CR waves. These two kinds of ultrasonic waves travel along the axial direction of the vessel's wall, bearing the same changes in pressure and temperature. The relationship between the reference transit time delay between two ultrasonic transducers and the pressure is established through theoretical analysis and calibration tests on an air vessel. To reduce the error caused by the unevenness of temperature distribution, which might occur in the vessel's and the transducer's material, a new kind of transducer is used in the experiment, which has two piezoelectric elements and can be used for the Rayleigh and L CR waves. A pair of such transducers is mounted along the axial direction of the air vessel. The penetration area of the Rayleigh wave is almost the same as that of the L CR wave with the use of the new transducers. Comparison tests between the new transducers and the custom-used transducers show that the new transducers have better repeatability. Finally, using the air vessel as a specimen, experimental results show that the reference method is effective and that the pressure values calculated using the reference method are close to the manometer-measured values.

Measurement of Sound Absorption by Underwater Acoustic Material Using Pulse-Separation Method

Measurement of the Echo Reduction for Passive Materials Based on Inverse Filtering Technique

Measurement of insertion loss for underwater acoustic passive materials with time reversal technique

Acoustic Insertion Loss Measurement Using Time Reversal Focusing

Measurement of the absorption coefficient for acoustical coating samples using multi-channel inverse filter

Sound absorption coefficient measurement by extracting the first reflected wave in a short tube

Measurement of acoustic properties for passive-material samples using multichannel inverse filter.

Measurements of the Low-Frequency Underwater Channel Features in a Littoral Environment Using a Plasma Sound Source

A low-frequency sound power measurement technique based on the separation of near-field acoustic energy flux in a non-anechoic tank

Measurements of the normal incidence sound absorption coefficient for Non-standard sized absorbers in impedance tubes

System error calculation and analysis of underwater sound absorption coefficient measurement experiment

A Novel Method for Holdup Measurement of Three Phases by an Ultrasonic Device with the Flexible Substrate

A Method Of Measuring The Acoustic Absorption Coefficient Of A Material Specimen At One End Of A Tube Using A Dynamic Microphone At The Other End

Simultaneously Measuring Thickness, Density, Velocity and Attenuation of Thin Layers Using V(z,t) Data from Time-Resolved Acoustic Microscopy.

Simultaneous Thickness, Velocity, Density, and Attenuation Measurement of a Thin Layer by Time-Resolved Acoustic Microscopy

Simultaneous Measurement of Elastic Moduli, Attenuation, Density, and Thickness of a Layer by Ultrasonic Spectroscopy Using Point-Focus Transducer

A Method of Measuring Acoustic Absorption Coefficient of a Material Specimen Using a Dynamic Microphone

Development and Applications of a Pressurized Water-Filled Impedance Tube

A New Nondestructive Technique for Measuring Pressure in Vessels by Surface Waves

A new technique for the measurement of the normal incidence absorption coefficient using an impedance tube and a single microphone with fixed position

Nondestructive Pressure Measurement in Vessels Using Rayleigh Waves and <formula> <tex>$l_{\rm CR}$</tex> </formula> Waves