Abstract:Unilateral surface compression in wood presents notable benefits, including reduced wood volume loss and energy consumption, rendering a highly promising and extensive utilization. However, shortcomings in compressed wood arise due to unclear gas pressure, temperature, and moisture content distribution within the wood during hot pressing. In this paper, the temperature and pressure distribution were analyzed utilizing an optical fiber temperature and pressure measurement system within the wood during hot pressing. Moreover, the moisture content, stress and strain in each layer at the end of hot pressing were discussed extensively. The results showed that the wood surface layer (SL) and subsurface layer (SSL) maximum temperature values were similar even with different layer thicknesses. Under sealing conditions, SL and SSL temperatures were generally 6 degrees C to 7 degrees C higher compared to unsealing conditions. The gas pressure maximum value exhibited an opposite order, gradually transferring to the core layer (CL) and declining as the processing time extended. During compression treatment, moisture migrated from the hot end to the cold within the wood. The moisture content displayed significant differences between the middle and end parts of the wood under unsealed conditions, with the disparity becoming more pronounced further away from the hot end. The transition region of the compressed wood served as a stress concentration area, experiencing the highest levels of stress. The dense region followed with the second highest stress levels, while the un-densified region exhibited the least amount of stress. Under the same process parameters, the thickness had little influence on the distribution of dense layers.

Lumber Drying Stresses and Mitigation of Cross-Sectional Deformation

Study on surface layer stress of small-diameter wood during drying process

Rheological Behavior of Larch Timber During Conventional Drying

Experimental and Numerical Study of Moisture Distribution and Shrinkage Crack Propagation in Cross Section of Timber Members

The Effect of Shrinkage Anisotropy on Tangential Rheological Properties of Asian White Birch Disks

The Effect of Layer Moisture Content Distribution on Lumber Surface and Bonding Interface Properties

Laws Governing Free and Actual Drying Shrinkage of 50 Mm Thick Mongolian Scotch Pine Timber

Moisture changes and surface checking development during drying of Masson pine wood

Fine Characterization and Analysis of Drying Strain of the ELM Board Via DIC Technology

Dynamic Thermo-Mechanical Analysis for the Compressive Rectangle Wood

Characterization of hygrothermal, gas pressure and stress characteristics for poplar wood during unilateral surface densification

Accelerated Weathering Performance of Plantation-Grown Juvenile Poplar and Chinese Fir Woods

Experimental study on local compression performance perpendicular to the grain for five different woods

Analysis of Deformation Fixation of Thermally Compressed Scots Pine (pinus Sylvestris L.)

Review on Wood Deformation and Cracking During Moisture Loss

The Relationship between Location in a Kiln and Drying Defects on Small-diameter Daimyo Oak Lumber

Analyzing the impact of veneer layup direction and heat treatment on plywood strain distribution during bending load by digital image correlation (DIC) technique

Investigation of surface damage mechanisms in milling heat-treated pine wood

Optimization of mechanical properties and dimensional stability of densified wood using response surface methodology

Compressive Mechanical Properties of Larch Wood in Different Grain Orientations

Stress Characteristics and Stress Reversal Mechanism of White Birch (betula Platyphylla) Disks under Different Drying Conditions