Abstract:Based on an improved shear-lag model, the effect of an inhomogeneous interphase on the mechanism of stress transfer in fiber-reinforced composites is investigated. The inhomogeneity of the interphase is represented by the graded feature of the Young’s modulus varying according to a power law or a linear one in the radius direction, while the Poisson’s ratio and thermal expansion coefficient are assumed to be constants. Considering the effects of the inhomogeneous interphase as well as the Poisson’s contraction and thermal residual stress, closed-form solutions to the axial fiber stress and interfacial shear stress are obtained analytically. Comparing the case with a power law to that with a linear one, we find that the fiber stress increases significantly in the former case, while it decreases slightly in the latter one with an increasing interphase thickness. With the same external tensile load and interphase thickness, it is found that the fiber in the power law case is subjected to a larger tensile stress than that in the linear variation one. However, the interfacial shear stress is not sensitive to the interphase thickness in both cases, except that near the two ends of fiber. Under the same external load, the maximum shear stress in the interphase is much smaller in the latter than that in the former. All the phenomena can be characterized by one parameter, i.e., the average Young’s modulus of interphase, and denote that an interphase with a power variation law is more effective for stress transfer while the linearly graded one is more advantageous to avoid shear failure. The results should be helpful for engineers to properly design the interphase in novel composites, e.g. a carbon-fiber reinforced epoxy one.

Investigation of the Effect of Microstructural Parameters on the Initial Yield Surface of Non-Isothermal Composites

Biaxial Yield Surface Investigation of Polymer-Matrix Composites

Effect of thermal residual stresses on yielding behavior under tensile or compressive loading of short fiber reinforced metal matrix composite

Temperature Effects on Transverse Failure Modes of Carbon Fiber/bismaleimides Composites

The Effects of Thermal Residual Stresses and Interfacial Properties on the Transverse Behaviors of Fiber Composites with Different Microstructures

Investigation on the Effects of Microstructure on Machining Unidirectional Carbon Fiber Reinforced Polymer Composites with a Modified Force Model

Initial and Final Failure Strength Analysis of Composites Based on a Micromechanical Method

Working Temperature Variation Effect on the Failure Envelope of Continuous Fiber-Reinforced Composites

Numerical Investigations of Microscopic Characteristic Influences on the Mechanical Properties of Polymer‐matrix Composites

Effects of thermal stress and imperfect interfacial bonding on the mechanical behavior of composites subjected to off-axis loading

Investigation of the Three-Dimensional Micromechanical Behavior of Woven-Fabric Composites

Predicting the Elastoplastic Response of Fiber-Reinforced Metal Matrix Composites

The Effect of a Graded Interphase on the Mechanism of Stress Transfer in a Fiber-Reinforced Composite

A Microscale Analysis of Thermal Residual Stresses in Composites with Different Ply Orientations

Dependence of Initial Stress–strain Behavior on Matrix Plastic Inhomogeneity in Short Fiber-Reinforced Metal Matrix Composite

An Analytical Study of the Influence of Thermal Residual Stresses on the Elastic and Yield Behaviors of Short Fiber-Reinforced Metal Matrix Composites

Modeling the Effects of Interfacial Properties on the Temperature Dependent Tensile Strength of Fiber Reinforced Polymer Composites

Effect of Residual Interface Stress on Thermo-Elastic Properties of Unidirectional Fiber-Reinforced Nanocomposites

Effects of interphase, CNT waviness and temperature on the Young's modulus of CNT/metal composites

THE THEORITICAL RESEARCH IN THE YIELDING BEHAVIOUR OF TENSILE DEFORMATION IN SHORT FIBER REINFORCED METAL MATRIX COMPOSITE

Micromechanical modeling of longitudinal compression behavior and failure mechanism of unidirectional carbon fiber reinforced aluminum composites involving initial fiber misalignment