Abstract:The disposal of wastewater sludge is one of the most challenging environmental problems for large cities. Wastewater sludge may be utilized as a feasible substitute for clay to sinter ceramics, given their similar mineralogical composition. However, the organics in sludge will be wasted, while their release during sintering will leave cracks in the ceramic products. In this research, after the thermal treatment for effective organic recovery, the thermally hydrolyzed sludge (THS) is incorporated with clay for the sintering of construction ceramics. The experimental results showed that a THS dosing ratio up to 40 % can be achieved for mixing with montmorillonite clay to make ceramic tiles. The sintered tiles (THS–40) had an intact shape and structure, and the tile performance was close to that made from single montmorillonite (THS–0), with water absorption of 0.4 % vs. 0.2 %, compressive strength of 136.8 vs. 140.7 MPa, and undetected heavy metal leaching. Further addition of THS would lead to a considerable deterioration of the quality of the tiles to a compressive strength of as low as 5.0 MPa for the THS only product (THS–100). Comparing with the tiles incorporated with raw sludge (RS–40), the THS–40 tiles had a more intact and denser structure with a 10 % improved compressive strength. Cristobalite, aluminum phosphate, mullite, and hematite dominated in the THS-born ceramics, which are typical components of ceramics, and the amount of hematite increased with the THS dosing ratio. Sintering at a high temperature of 1200 °C enabled efficient phase transformation from quartz to cristobalite and from muscovite to mullite, which ensured the toughness and compactness of the THS-born ceramic tiles.

Effect of Sintering Temperature and Time on Preparation of Ceramic Tiles Made from Tungsten Tailings

The Effects of Mineral Composition and Sintering Temperature on Synthetic Mullite

Impact of the Mineral Composition and Sintering Temperature on the Synthesis of Anorthite Ceramics

Effect of Crystallization Temperature on Glass-Ceramics Derived from Tailings Waste

Sintering behavior and mechanical properties of sintered ceramics based on spodumene tailings

Sintering Behavior and Technological Properties of Low-Temperature Porcelain Tiles Prepared Using a Lithium Ore and Silica Crucible Waste

Valorization of thermally hydrolyzed sludge with clay for sintering of ceramic tiles

Effective utilization of extracted titanium tailing to prepare high performance glass-ceramic and their formation mechanism

Sintering effects on the development of mechanical properties of fired clay ceramics

Study on Preparation Technology and Properties of Tiutai Porous Ceramics

Effects of sintering parameters on the preparation and properties of foamed ceramics from cyanide tailings

Effect of glass content on sintering kinetics, microstructure and mechanical properties of glass-ceramics from coal fly ash and waste glass

Utilization of both Electronical Manganese Slag and Silicate Tailings as Raw Materials for Fabrication of Cost-effective Porous Ceramics

Preparation of permeable ceramic bricks with tungsten tailings by two-stage calcination technology

Effect of Sintering Temperature on the Structures and Properties of Porous Aluminium Titanate Ceramics

The Effect of Sintering Temperature on Phase-Related Peculiarities of the Microstructure, Flexural Strength, and Fracture Toughness of Fine-Grained ZrO2–Y2O3–Al2O3–CoO–CeO2–Fe2O3 Ceramics

Preparation and Performance of Ceramic Tiles with Steel Slag and Waste Clay Bricks

Preparation of Gold Tailing Ceramic Tile Containing Bamboo Charcoal

Effects of sintering temperature on properties of porous mullite/corundum ceramics

Preparation and characterization of ceramic foams mainly containing extracted titanium residues and silica tailings

Effect of calcination and sintering temperature on porosity and microstructure of porcelain tiles