Abstract:In this paper, a model of flood area display and damageevaluation is discussed, which adopts seed spread algorithm to calculate and visualize flood area based on a DEM data set and under the condition of a given water level of flood. The raster image containing flood area is overlaid with raster data converted from thematic vector maps such as land-use map and related to other socio-economic data, and then quantitative evaluation of flood damage is achieved. There are two different cases, the so-called “non-source flood” and “source flood”, for determining flood area based on DEM and under the given water level condition. Non-source flood corresponds to the case with well-distributed and large-area rainfall where all the low-lying land may have a flood disaster, and in this case all the points with elevations below the given water level should be included in the flood area. The “source flood” is the case of flood (e.g. from bank burst) flushing through the surrounding lands that needs to consider “ci rculating” condition. Because flood may be obstructed by ring structures or high lands, thus it can only cover the place where it flows and reaches. One of the computer processing methods suitable for source flood is the seed-spread algorithm. The principle of this method is to select a representative pixel as a seed and to examine its contiguous pixels outward along 4 or 8 directions. The pixels, contiguous to it and meeting the given conditions, become seeds, and then contiguous pixels to the new seeds will be examined in the same way. This process repeats until an aggregation of the pixels which meet the given conditions on a certain plane are obtained. Adopting seed spread algorithm for source-flood area calculation is just to achieve an aggregation of pixels, which satisfies the connectivity requirement and the given conditions of water level. The initial position of seed pixel should usually be selected on the characteristic points, e.g. adjacent to a reservoir dam or stream boundary. The precision of flood area calculation is mainly determined by spatial resolution of the DEM, the area on the ground is represented by each pixel; whereas the accuracy of flood area calculation, to a great extent, is dependent on the preci sion of the DEM's pixel value or elevation.Once the area below the flood water level has been calculated, the flood damage evaluation can be calculated by overlaying the flood range with thematic maps and by relating to other socio-economic data. All thematic maps were converted to raster data because algorithm of the overlay analysis implemented in raster format is relatively simple and computing is fast. In order to improve accuracy of the flood damage evaluation it is necessary to accurately register and georefer all raster layers before overlay analysis. The calculation results of flood damage evaluation are generally represented by tabulation, which is a kind of classified statistics of flood damage data, e.g. a table representing total area of every land-use type in different administrative divisions. The results of flood area calculation and damage evaluation can also be visually and dynamically provided in the forms of graph, image, 3D or virtual reality. The model has been successfully applied in the “Zhejiang Provincial Water Conservancy Management System” developed for a national project.

Emergency evacuation planning against dike-break flood: a GIS-based DSS for flood detention basin of Jingjiang in central China

Modeling of Dike-Break Induced Flood Routing Process and Flood Risk Assessment in Detention Basins

Enhancing Flood Risk Assessment and Mitigation Through Numerical Modeling: A Case Study

A GIS-based 3D Visual Simulation System for Flood Protection

Dike-Break Induced Flood Simulation and Consequences Assessment in Flood Detention Basin

A GIS-based Method for Flooded Area Calculation and Damage Evaluation

A GIS Based Model for Calculating of Flood Area

Management System for Dam-Break Hazard Mapping in a Complex Basin Environment

Gis-Based Flood Evacuation Planning : Evacuation Mapping

Flood Routing Numerical Simulation in Jingjiang Diversion Area Based on MIKE FLOOD Model

Urban Flood Maping for Jiaxing City Based on Hydrodynamic Modeling and GIS Analysis

Loss Assessment of Dike-Break Induced Flood Disaster: A Case Study in the Poyang Lake District in China

GIS-based Emergency Response System for Sudden Water Pollution Accidents

Flood Area and Damage Estimation in Zhejiang, China

A Gis-Supported Impact Assessment of the Hierarchical Flood-Defense Systems on the Plain Areas of the Taihu Basin, China

According to the standards and requirements of flood risk mapping guidelines set by the Ministry

Study on the Deduction of Flood Situation in Yangtze River Basin Based on Virtual Earth.

Risk assessment of urban flood disaster in Jingdezhen City based on analytic hierarchy process and geographic information system

Flood Submergence Simulation and Risk Analysis Based on GIS in Plain Area

Gis Application in Analysis of Flood Inundation

A GIS-Based Spatial Multi-Criteria Approach for Flood Risk Assessment in the Dongting Lake Region, Hunan, Central China