Abstract:The HfOx-based resistive random access memory (RRAM) has been extensively investigated as one of the emerging nonvolatile memory (NVM) candidates due to its excellent memory performance and compatibility with CMOS process. In this study, the influences of deposition ambient, especially the oxygen partial pressure during thin film sputtering, on the resistive switching characteristics are discussed in detail for possible nonvolatile memory applications. The Ni/HfOx/TiN RRAMs are fabricated, and the HfOx films with different oxygen content are deposited by a radio frequency magnetron sputtering at room temperature under different oxygen partial pressures. The oxygen partial pressures in the sputter deposition process are 2%, 4% and 6% relative to engineer oxygen content in the HfOx film. Current-voltage (I-V) measurements, X-ray photoelectron spectroscopy, and atomic force microscopy are performed to explain the possible nature of the stable resistive switching phenomenon. Through the current-voltage measurement, typical resistive switching behavior is observed in Ni/HfOx/TiN device cells. It is found that with the increase of the oxygen partial pressure during the preparation of HfOx films, the stoichiometric ratio of O in the film is improved, the root mean square (RMS) of the surface roughness of the film slightly decreases due to the slower deposition rate under a higher oxygen partial pressure, and the high resistance state (HRS) current decreases. In addition, by controlling the oxygen content of the device, the endurance performance of the device is improved, which reaches up to 10 3 under a 6% oxygen partial pressure. The HfOx films prepared at a higher oxygen partial pressure supply enough oxygen ions to preserve the switching effect. As the oxygen partial pressure increases, the uniformity of the switching voltage is improved, which can be attributed to the fact that better oxidation prevents the point defects (oxygen vacancies) from aggregating into extended defects. Through the linear fitting and temperature test, it is found that the conduction mechanism of Ni/HfOx/TiN RRAM device cells in low resistance state is an ohmic conduction mechanism, while in high resistance state it is a Schottky emission mechanism. The interface between TE and the oxide layer (HfOx) is expected to influence the resistive switching phenomenon. The activation energy of the device is investigated based on the Arrhenius plots in HRS. A switching model is proposed according to the theory of oxygen vacancy conductive filament. Furthermore, the self-compliance behavior is found and explained.

Effects of Film Thickness and Ar/O-2 Ratio on Resistive Switching Characteristics of Hfox-Based Resistive-Switching Random Access Memories

The Improved Resistive Switching of HfO2:Cu Film with Multilevel Storage

Resistance Switching of HfO_x Film for RRAM Applications

Bipolar Resistive Switching Characteristics of Tin/Hfox/Ito Devices for Resistive Random Access Memory Applications

Investigation of Resistive Switching in Cu-Doped Hfo2 Thin Film for Multilevel Non-Volatile Memory Applications

Influneces of Different Oxygen Partial Pressures on Switching Properties of Ni/HfOx/TiN Resistive Switching Devices

Study on Resistive Switching Characteristics and Mechanisms of Cu/SiOx/TiN Structure Resistive Random Access Memory

Resistive Switching Characteristics of Pt/TaOx/HfNx Structure and Its Performance Improvement

Resistive switching of the HfOx/HfO2 bilayer heterostructure and its transmission characteristics as a synapse

Effect Of Tiox Film Thickness On Resistive Switching Behavior Of Tin/Tiox/Hfo2/Pt Rram Device

Charge Transport and Bipolar Switching Mechanism in a Cu/HfO 2 /pt Resistive Switching Cell

Study of Multilevel High-Resistance States in HfOx-Based Resistive Switching Random Access Memory by Impedance Spectroscopy

Enhancement of Resistive Switching Performance in Hafnium Oxide (HfO2) Devices via Sol-Gel Method Stacking Tri-Layer HfO2/Al-ZnO/HfO2 Structures

Resistive Switching Characteristics Of Hfo2 Thin Films On Mica Substrates Prepared By Sol-Gel Process

Grain Boundaries As Preferential Sites For Resistive Switching In The Hfo2 Resistive Random Access Memory Structures

Complementary Resistive Switching Behavior Induced by Varying Forming Current Compliance in Resistance Random Access Memory

Effects of Oxygen Partial Pressure on the Sputtered Hafnium Oxide Thin Films for Resistive Random-Access Memory

Resistive Switching Behavior of Hafnium Oxide Thin Film Grown by Magnetron Sputtering

Resistive switching of the HfO<sub>x</sub>/HfO<sub>2</sub> bilayer heterostructure and its transmission characteristics as a synapse

Enhanced Resistive Switching Behaviors of HfO2:Cu Film with Annealing Process

Effects of Electrodes on the Filament Formation in HfO2-Based Resistive Random Access Memory