Thermal Performance Analysis and Operation of the Spoke Cavity Cryomodules for C-ADS Injector-I
Ruixiong Han,Zhengping Zou,Rui Ge,Shaopeng Li,Lin Bian,Liangrui Sun,Minjing Sang,Rui Ye,Quanling Peng,Xiangzhen Zhang,Jianqin Zhang,Zhuo Zhang,Jiehao Zhang,Miaofu Xu,Zhengze Chang,Tongming Huang,Feisi He,Chenglian Liu
DOI: https://doi.org/10.1016/j.cryogenics.2019.06.002
IF: 2.134
2019-01-01
Cryogenics
Abstract:The Chinese Accelerator Driven Sub-critical system (C-ADS) is an important strategic research that is based on a high energy proton beam for nuclear waste transmutation. To meet the requirements of stability and reliability of the lower energy part, two identical Injectors are operated in parallel. The Injector-I is designed and constructed by the Institute of High Energy Physics (IHEP) of the Chinese Academy of Sciences (CAS) in Beijing, China. The Injector-I linac with two accelerating cryomodules (named CM1 and CM2) successfully accelerated the proton beam to 10.67 MeV with the beam current of 10.11 mA in pulse mode and 10.0 MeV with a beam current of 1.6 mA in CW (continuous wave) mode. The cryomodules have been designed, fabricated, assembled and commissioned at IHEP since the beginning of 2012. The thermal performances of the cryomodules were analyzed with numerical simulations and the empirical calculations take into account all the main contributors (support posts, multilayer insulation, current leads, power couplers and cavities) to the static and dynamic heat loads at various temperature levels. Two designs of current leads are developed and analyzed, and the case 2 current leads are tested and used in the CM2. The estimated static heat loads by analysis have been compared with the available experimental measurements. The operation experiences including the cool down, operating parameters and heat load measurements are reported, and the results were shown that the cryomodules can keep in a stable operation at 2 K and 30 mbar +/- 10 Pa.