Microstructure, properties and fracture failure mechanism of MAG welded joints of four types of stainless steels
Jihua Liu,Pijie Yu,Peng Chen,Shitao Chen,Roger Lewis,Zhibiao Xu,Peng Li,Chenggang He
DOI: https://doi.org/10.1016/j.engfailanal.2023.107326
IF: 4
2023-05-17
Engineering Failure Analysis
Abstract:In this study, four types of austenitic stainless steels (SUS 301L, SUS 304, SUS 316L and SUS 321) with different chemical compositions were butt welded by using MAG (metal active gas) welding. Unique information was gained by studying the solidification mode, microstructure and mechanical properties of the four welded joints under the same welding process, and their fracture mechanisms were analyzed from the perspective of crystallography. The results indicate that the microstructure of the four austenitic stainless steel base metals is uniformly sized equiaxed austenite with δ-ferrite distributed inside or at the boundary of austenite grains in 301L and 304 base metals. The welds of the four kinds of stainless steels are solidified in Austenitic-Ferrite (AF) solidification mode, and the final microstructures of the 301L, 304 and 316L weld are equiaxed grains while the 321 stainless steel weld grows into a dendritic structure due to its low temperature gradient. The microstructures of the fusion zone (FZ)/fine equiaxed zone (FQZ) and heat affected zone (HAZ) of the four types of stainless steels are closely related with the solidification mode of FZ, i.e. small FZ and HAZ regions result from Ferrite (F) solidification mode present in the 301L and 321 welded joints. However, larger FQZ regions generate in the 304 and 316L welded joints due to the Ferrite-Austenitic (FA) solidification mode. The 304 and 316L stainless steel tend to fracture at the HAZ positions due to the formation of FQZ; large angle grain boundary formed at the weld of 301L stainless steel is the reason for its fracture, and the good anisotropy of the weld and heat affected zone of 321 stainless steel also makes it easier to fracture in the base metal (BM). The section hardness distribution characteristics of the four stainless steels welded joints also verify their fracture tendency.
engineering, mechanical,materials science, characterization & testing