Abstract:This article investigates the performance of finite element model updating to identify the induced damage in a two-story reinforced concrete masonry-infilled building using vibration data as well as lidar (light detection and ranging) scans. The building, located in El Centro, California, was severely damaged due to the 2010 El Mayor–Cucapah (Baja California, Mexico) Earthquake, and it was planned to be demolished following a number of ambient and forced vibration tests. The forced vibration tests were performed using an eccentric mass shaker. During the testing sequence, damage was induced to the building by removing four exterior walls. The modal parameters of the structure are estimated using the ambient vibration and forced vibration measurements at the reference state and damaged state. Lidar data are also used to detect surface defects and quantify the temporal changes of surface defects caused by the wall removal and forced vibration tests. Based on site inspections, geometry measurements, and material test data, two initial finite element models are built, namely the un-tuned initial model and the tuned initial model. The tuned initial model implements stiffness reduction factors to account for the observed damage in the building at its reference state while the un-tuned model does not. Two sets of reference models are calibrated to represent the structure at the reference state using the un-tuned and tuned initial models. The reference models are then updated to fit the measured data at the damaged state of the building with damage being estimated as the loss of stiffness in updating substructures. The estimated damage is compared to the nominal value of induced damage and surface defects detected by lidar scans. The analysis of the results indicates that the un-tuned and tuned initial models provide similar updated models and damage identification results which are in good agreement with the nominal values of damage and lidar detection results.

Finite-Element Model Updating for Assessment of Progressive Damage in a 3-Story Infilled RC Frame

An application of finite element model updating for damage assessment of a two-story reinforced concrete building and comparison with lidar

Nonlinear finite element model updating with a decentralized approach

Model updating for RC frame based on shaking table test and identification of simulated damage

In situ lateral-loading test and micro-macro-scale simulation of an existing RC frame

Mapping Structural Damage to Material Damage for Analysis of Urban Buildings Considering Actual Damage States

Seismic Damage Analysis of Reinforced Concrete Frame Using the Force Analogy Method

Modal Strain Energy-Based Model Updating Method for Damage Identification on Beam-Like Structures

Performance of Simplified Damage-Based Concrete Models in Seismic Applications

Damage Inference and Residual Capacity Assessment for an E-Defense 2018 Ten-Story RC Test Structure

APPLICATION OF STORY DAMAGE MODEL BASED SEISMIC ASSESSMENT APPROACH: CASE STUDY OF EXISTING RC FRAME STRUCTURES

Structural Damage Identification Based on Model Updating

A Generalized Multi-Level Seismic Damage Model for RC Framed Structures

Earthquake-induced Damage Updating for Remaining-Life Assessment of Steel Frame Substructure Systems

Finite Element Model Updating Using Evolutionary Strategy for Damage Detection

Nonlinear Modeling of the Ten-Story RC Building Structure of 2015 E-Defense Shaking Table Tests

Nonlinear Seismic Analysis of City Gate Architectural Heritages Using a Sensitive-Based Model Updating Method

Experimental validation of an efficient strategy for FE model updating and damage identification in tubular structures

Finite element model updating for structural damage detection using transmissibility data

Modal Identification of a 5-Story RC Building Tested on the NEES-UCSD Shake Table

Monitoring the changes in the dynamic properties of an RC building experiencing column loss