Abstract:To investigate the compressive behavior of concrete under a freeze-thaw environment, porosity swelling theory, a damaged plastic model, and an element removal technique are combined to propose a novel mesoscopic numerical model of concrete. The porosity swelling theory is employed to represent the pores evolution behavior of concrete under freeze-thaw cycles, and a novel calculation method for porosity expansion is presented to characterize freeze-thaw cycle times. The damaged plastic model is used to describe the tensile and compressive features of the mortar and interface transition zone. The element removal technique with maximum damage criterion is employed to implement crack propagation. It was demonstrated that the model could capture the freeze-thaw damage and compressive failure of concrete well. The uniaxial compressive behavior of five random mesonumerical models of freeze-thaw concrete was investigated. The results showed that freeze-thaw cycles can cause tensile damage to the mortar near pores and the spalling of surface mortar. With the increase of concrete freeze-thaw cycles, the dispersion degree of the compressive stress–strain curve gradually rises, and the peak stress and peak strain of the freeze-thaw concrete stress–strain curve decrease and increase, respectively. During the freeze-thaw cycles, the sustained preload will decrease the compressive strength because it causes the microcracks to accelerate the damage induced by the freeze-thaw cycles. Then, the influence of mortar and interface transition zone properties on the compressive strength of concrete under freeze-thaw cycles was analyzed. Under 100 freeze-thaw cycles, the maximum attenuation rates of concrete compressive strength increase by 9.39% and 34.26% with the increase of interface transition zone and mortar properties, respectively. Increasing mortar properties and decreasing the sustained preload will enhance the ability of concrete to resist freeze-thaw cycles.

Mesoscale Simulation of Deformation for Mortar and Concrete under Cyclic Freezing and Thawing Stress

Meso-scale mechanical model for mortar deformation under freeze thaw cycles

Modeling and Mesoscale Simulation of Ice-Strengthened Mechanical Properties of Concrete at Low Temperatures

A Dynamic FEM-DEM Multiscale Modeling Approach for Concrete Structures

Mesoscale Simulation of Concrete Behavior with Non-Uniform Frost Damage with Verification by CT Imaging

Stress Analysis for Concrete Materials under Multiple Freeze-Thaw Cycles

Mesoscale Simulation of Fatigue Behavior of Concrete Materials Damaged by Freeze-Thaw Cycles

Two‐dimensional Rigid Body Spring Method Based Micro‐mesoscale Study of Mechanical Strengthening/damaging Effects to Concrete by Frost Action

RBSM-based Mesoscale Study of Frost Deterioration for Recycled Concrete Considering Air-Entrainment in Old and New Mortar

Development of Internal Moisture Transfer and Cumulative Residual Strain in Concrete under Freeze-Thaw Cycles

Mesoscale Simulation of Bond Behaviors Between Concrete and Reinforcement under the Effect of Frost Damage with Axisymmetric Rigid Body Spring Model

Structural behaviors evaluation of RC beam under frost damage - A methodology with meso-macro material/bond simulation and integrating into structural analysis

Mesoscale simulation of frost damage to rock material based on Rigid Body Spring Method

Experimental Investigation of the Deformational Behavior of the Interfacial Transition Zone (itz) in Concrete During Freezing and Thawing Cycles

Meso-Scale Failure of Freezing–Thawing Damage of Concrete under Uniaxial Compression

RBSM based analysis on mechanical degradation of non-air entrained concrete under frost action – A general prediction with various water cement ratio, lowest temperatures and FTC numbers

Micromechanical modeling of frozen concrete by micro-deformation of multi-phase composite material

Change of the Coefficient of Thermal Expansion of Mortar Due to Damage by Freeze Thaw Cycles

Three-Dimensional Mesonumerical Model of Freeze-Thaw Concrete Based on the Porosity Swelling Theory

A Mesoscale Modelling Approach Coupling SBFEM, Continuous Damage Phase-Field Model and Discrete Cohesive Crack Model for Concrete Fracture

Numerical simulation of the freezing process of concrete