Hierarchically Structured Periodic Mesoporous Silica by Vapor Phase Synthesis

Limin Guo,Yong Fan,Hiroyuki Arafune,Norio Teramae
DOI: https://doi.org/10.1016/j.micromeso.2012.06.022
IF: 5.876
2012-01-01
Microporous and Mesoporous Materials
Abstract:Periodic mesoporous silica was synthesized within the pores of an anodic alumina membrane (AAM) by acid-catalyzed vapor phase synthesis. Three different surfactants, ionic cetyltrimethylammonium bromide (CTAB) and nonionic F127 and P123, were used as a structure directing agent (SDA). Surfactant solution containing HCl was introduced into the AAM pores under moderate aspiration to avoid the formation of an undesirable mesoporous silica layer on the AAM surface. As-prepared samples were investigated by scanning electron microscope (SEM), transmission electron microscope (TEM), small-angle X-ray diffraction and nitrogen sorption measurements. When using CTAB as an SDA, columnar hexagonal, circular hexagonal, and columnar hexagonal surrounded by circular hexagonal mesostructures were formed depending on the mass ratio of CTAB to HCl solution. This was a new observation in contrast to the previous reports where only the hexagonal columnar structure was obtained for CTAB irrespective of synthesis conditions. When F127 was used as an SDA, a cubic mesostructure was formed and the cubic mesostructure could be synthesized over a relatively wide concentration range of F127. When using P123 as an SDA, various mesostructures were formed such as disordered lamellar, silica nanotube filled with closely stacked silica nanoparticles, inverse circular hexagonal, inverse columnar hexagonal, and lamellar structures. These characteristic mesostructures within AAM pores were observed for the first time. In addition, a high filling factor was confirmed for all structural types of mesoporous silica within the AAM pores.
What problem does this paper attempt to address?