Abstract:The solidification mechanism and segregation behavior of laser-melted Mn35Fe5Co20Ni20Cu20 was firstly investigated via in situ synchrotron x-ray diffraction at millisecond temporal resolution. The transient composition evolution of the random solid solution during sequential solidification of dendritic and interdendritic regions complicates the analysis of synchrotron diffraction data via any single conventional tool, such as Rietveld refinement. Therefore, a novel approach combining a hard-sphere approximation model, thermodynamic simulation, thermal expansion measurement and microstructural characterization was developed to assist in a fundamental understanding of the evolution of local composition, lattice parameter, and dendrite volume fraction corresponding to the diffraction data. This methodology yields self-consistent results across different methods. Via this approach, four distinct stages were identified, including: (I) FCC dendrite solidification, (II) solidification of FCC interdendritic region, (III) solid-state interdiffusion and (IV) final cooling with marginal diffusion. It was found out that in Stage I, Cu and Mn were rejected into liquid as Mn35Fe5Co20Ni20Cu20 solidified dendritically. During Stage II, the lattice parameter disparity between dendrite and interdendritic region escalated as Cu and Mn continued segregating into the interdendritic region. After complete solidification, during Stage III, the lattice parameter disparity gradually decreases, demonstrating a degree of composition homogenization. The volume fraction of dendrites slightly grew from 58.3 to 65.5%, based on the evolving composition profile across a dendrite/interdendritic interface in diffusion calculations. Postmortem metallography further confirmed that dendrites have a volume fraction of 64.7% ± 5.3% in the final microstructure.

Solidification Microstructures of the Undercooled Co–24at%Sn Eutectic Alloy Containing 0.5At%mn

Non-equilibrium solidification of bulk undercooled Ni–P eutectic alloys

Effect of Minor Addition of Co on Nonequilibrium Solidification of Deeply Undercooled Cu Based Alloys

Crystal structure and microstructure of rapidly solidified La(Ni, Sn)(5+x)(x=0.1-0.4) hydrogen storage alloys

Effects of Cu Addition on the Microstructure and Properties of the Al–Mn–Fe–Si Alloy

Effect of Co Addition on Solidification Velocity, Hardness and Refined Structure Transformation Mechanisms of Undercooled Ni-Cu-Co Alloys

Microstructural, thermal and mechanical properties of Co added Sn–0.7Cu lead-free solder alloy

Influence of Mn Addition on the Evolution of Precipitates in Al-Cu Alloys

Effects of Co Alloying and Size on Solidification and Interfacial Reactions in Sn-57 Wt.%bi-(Co)/cu Couples

Analysis of the microstructural evolution and solidification behaviour of Sn-9 wt% Zn alloy with small additions of Mg

Solidification behavior of Sn crystals − Under different temperature gradients

Effect of Mn on eutectic phase equilibria in Al-rich Al-Ce-Ni alloys

Microstructure Characterization, Structure and Magnetic Properties of Ni–Mn–Sn Shape Memory Alloys

Effect of Fe and Mn Content on the Microstructures and Tensile Behaviour of AlSi7Cu3 Alloy: Thermal Analysis and Tensile Tests

W–Sn solid solution synthesized by mechanical alloying at room temperature

The Effect of Solidification Rate on the Microstructure and Electrochemical Properties of Co-free Ml(NiMnAlFe)5 Alloys

Microstructure Changes in Sn- or Gd-Modified Cu–11%Al–10%Mn Alloy

Co alloying and size effects on solidification and interfacial reactions in the Sn−Zn−(Co)/Cu couples

Microstructure and tensile properties of Sn-1Cu lead-free solder alloy produced by directional solidification

In situ synchrotron diffraction and modeling of non-equilibrium solidification of a MnFeCoNiCu alloy

Study on the Microstructure of Mg-4Zn-4Sn-1Mn-xAl As-Cast Alloys