Mechanical and Tribological Properties of Self-Reinforced Polyphenylene Sulfide Composites

Yuning Ma,Peihong Cong,Haiming Chen,Ting Huang,Xujun Liu,Tongsheng Li

DOI: https://doi.org/10.1080/00222348.2015.1061845

2015-01-01

Journal of Macromolecular Science Part B

Abstract:25%, 50%, and 75% polyphenylene sulfide (PPS) long fiber reinforced PPS resin were prepared by a hot pressing method. Neat resin PPS and PPS fiber samples were also prepared to compare with the self-reinforced PPS composites. The reinforcing fibers were preheat treated at 240°C for 24 h. The tribological properties of the self-reinforced PPS composites against an AISI 1045 steel ring were determined by a block on ring type friction tester. Differential scanning calorimetry (DSC) results indicated that a higher degree of crystallinity was retained in the self-reinforced PPS composites than in neat PPS resin after hot pressing. Therefore, the addition of PPS fiber improved both the mechanical and tribological properties of PPS resin significantly. Dynamic mechanical analysis (DMA) demonstrated that the PPS fibers increased the glass transition temperature (Tg) of the PPS resin. SEM images of the fracture surfaces indicated that the toughness of the samples increased with increasing PPS fiber content. Additionally, PPS fibers improved the tribological properties of PPS resin by significantly reducing the friction coefficient and wear rate.