Abstract:The PSf casting solution required degassing, sealing, and humidity and temperature control.PA layer formation on the top surface of the PSf substrate resulted in the highest FO performance.GO modification of the PA layer considerably enhanced water flux and reduced reverse solute fluxThe FO membranes exhibited high rejection efficiency for dyes used in the textile industry.The application of FO for water recovery is economic and environmentally friendly.In this study, the preparation procedures for the polysulfone (PSf) substrate and polyamide (PA) selective layers were systematically investigated to determine their effects on the separation performance of thin-film composite (TFC) forward osmosis (FO) membranes in terms of the permeate flux (Jw) and reverse solute flux (Js). Furthermore, the PA active layer was modified by adding different proportions of an emerging material, graphene oxide (GO), to increase Jw and decrease Js. The experimental results indicated that special attention should be paid to the preparation of the PSf casting solution, which required thorough degassing, sealing, and humidity and temperature control. The optimum casting height was discovered to be 175 μm. For PA layer formation, the same amount of polymer solutions (resulting thickness of 78.5 μm) on the top surface of the PSf substrate (on the side facing the water during phase inversion) resulted in the highest FO performance. GO modification of the PA layer at the dosage of 0.0175 wt% considerably enhanced Jw to 14 L m−2 h−1 and reduced Js to 0.23 mol m−2 h−1. However, higher GO dosage (0.02 wt%) led to lower membrane performance due to aggregation of GO nanoparticles, as confirmed using scanning electron microscopy. Next, the prepared membranes were applied to dye rejection and sludge concentration for water recovery. The virgin and modified FO membranes both exhibited high rejection efficiency (≥ 96.0%) for dyes commonly used in the textile industry. The 0.0175%-GO-modified FO membrane exhibited a higher concentration factor (1.67) and greater water recovery (40.0%) than the virgin membrane (1.45 and 31.2%, respectively). Therefore, the application of FO for water recovery is economic and environmentally friendly in terms of saving the transportation cost of sludge disposal while recovering water for reuse in wastewater treatment plants.

Explore the forward osmosis performance using hydrolyzed polyacrylamide as draw solute for dye wastewater reclamation in the long-term process

Water reclamation from emulsified oily wastewater via effective forward osmosis hollow fiber membranes under the PRO mode

Thermo-responsive nonionic amphiphilic copolymers as draw solutes in forward osmosis process for high-salinity water reclamation

A novel conductive carbon-based forward osmosis membrane for dye wastewater treatment

Optimized preparation route for polyamide top-coated forward osmosis membrane for enhanced water flux using industrial wastewater as feed

Research on the appIication of forward osmosis to zero discharge treatment process of coaI chemicaI industriaI wastewater

Antifouling forward osmosis membranes by ε-polylysine mediated molecular grafting for printing and dyeing wastewater: Preparation, characterization, and performance

Fabrication and modification of forward osmosis membranes by using graphene oxide for dye rejection and sludge concentration

A study of Forward Osmosis Performance and its Application on Sodium Succinate Feed Solution Using Ionic Salt Draw Solution

Utilization of unrejected ammonium for fouling prevention in a forward osmosis process tested with real primary wastewater from Hong Kong

Forward Osmosis Membrane: Review of Fabrication, Modification, Challenges and Potential

Feasibility of Poly (Vinyl Alcohol)/Poly (Diallyldimethylammonium Chloride) Polymeric Network Hydrogel as Draw Solute for Forward Osmosis Process

Black odorous water concentrating by forward osmosis (FO) with aquaporin biomimetic membranes: Pollutants concentrating and membrane fouling characteristics

Towards enhanced performance of fertilizer-drawn forward osmosis process coupled with sludge thickening using a thin-film nanocomposite membrane interlayered with Mxene scaffolded alginate hydrogel

Application of Polysaccharide Derivatives As Novel Draw Solutes in Forward Osmosis for Desalination and Protein Concentration

Research progress of reverse draw solute permeation in forward osmosis process

Evaluating the performance of inorganic draw solution concentrations in an anaerobic forward osmosis membrane bioreactor for real municipal sewage treatment

Integrating reverse osmosis and forward osmosis (RO-FO) for printing and dyeing wastewater treatment: impact of FO on water recovery

Feasibility of applying forward osmosis to the simultaneous thickening, digestion, and direct dewatering of waste activated sludge.

Perfluorooctanoic acid-contaminated wastewater treatment by forward osmosis: Performance analysis

Effects of Feed Solution Ph and Draw Solution Concentration on the Performance of Phenolic Compounds Removal in Forward Osmosis Process