Abstract:Experimental design showing electrode layout and recorded spectral induced polarization (SIP) data. The left half of the zoomed‐in region shows the equilibrium state with no applied electrical field. The right half shows the situation whereby an electrical field causes the cations to migrate on the surface of mineral grains; a phenomena which can be measured with the SIP instrumentation. This study investigates the potential of field‐based induced polarization (IP) methods to provide in‐situ estimates of soil cation exchange capacity (CEC). CEC influences the fate of nutrients and pollutants in the subsurface. However, estimates of CEC require sampling and laboratory analysis, which can be costly, especially at large scales. Induced polarization (IP) methods offer an alternative approach for CEC estimation. The sensitivity of IP measurements to the surface properties of geological materials ought to make them more appropriate than DC resistivity and electromagnetic induction methods, that are sensitive to bulk electrical properties . Such abilities of IP are well demonstrated in the laboratory; however, applications are lacking at field scales. In this work, the ability of field‐based IP to characterize the CEC of floodplain soils is assessed by implementing a methodology that allows for direct comparison between IP and soil parameters. In one field, soil polarization and CEC exhibited the expected positive correlation; but multi‐frequency measurements showed no clear advantage over single‐frequency measurements. In another field, coarser soils (with low CEC) exhibited a high polarization. These coarser soils were characterized by anomalous magnetic susceptibility values, and hence the polarization was attributed to the presence of magnetic minerals. Although better than order‐of‐magnitude estimates of CEC were possible in soils without substantial magnetic minerals, better characterization of porosity, saturation, cementation and saturation exponents, and pore fluid conductivity would improve predictions. However, the measurement of these parameters would require similar efforts as direct CEC measurements. This study contributes to bridging the gap between laboratory‐derived relationships and their applicability in field applications. Overall, this work provides valuable insight for future studies seeking to understand polarization mechanisms in soils at the field scale.

Evaluating the potential for quantitative monitoring of in situ chemical oxidation of aqueous‐phase TCE using in‐phase and quadrature electrical conductivity

Real-time monitoring of in situ chemical oxidation (ISCO) of dissolved TCE by integrating electrical resistivity tomography and reactive transport modeling

Quantitative Assessment of Monitoring Natural Attenuation on Carbon Tetrachloride Reduction at a Groundwater-Contaminated Site in Eastern China

A third parallel visual pathway to primate area V1

In-Situ Generation Of Active Oxidants In Permeable Reactive Barriers

Low Permeability Zone Remediation of Trichloroethene Via Coupling Electrokinetic Migration with in Situ Electrochemical Hydrodechlorination.

Compatibility of chelators with permanganate for chelator-enhanced permanganate-based ISCO remediation of chlorinated ethenes DNAPLs

Quantitative study of in situ chemical oxidation remediation with coupled thermal desorption

Thermal conductive heating coupled with in situ chemical oxidation for soil and groundwater remediation: A quantitative assessment for sustainability

A dead-zone based filter for systems with unknown parameters

Quantification of Oxidant Demand and Consumption for In Situ Chemical Oxidation Design: in the Case of Potassium Permanganate

Evolution of in-situ thermal-enhanced oxidative remediation monitored by induced polarization tomography

Assessment of the functionality of a pilot-scale reactor and its potential for electrochemical degradation of calmagite, a sulfonated azo-dye

Detection of Ionic Contaminants in Unsaturated Soils Using Time Domain Reflectometry Penetrometer

Editors' Disclosure of Potential Conflicts of Interest.

Field‐based estimation of cation exchange capacity using induced polarization methods

Response of TCE biodegradation to elevated H2 and O2: Implication for electrokinetic-enhanced bioremediation

Oxidative degradation of pentachlorophenol by permanganate for ISCO application

Monitoring and Characterizing the Whole Process of Microbially Induced Calcium Carbonate Precipitation Using Electrical Resistivity Tomography

Application of Cyclic Voltammetry with W Electrodes for Measurement of High CaO Concentration in Molten CaCl2

DNAPL remediation with in situ chemical oxidation using potassium permanganate. Part I. Mineralogy of Mn oxide and its dissolution in organic acids