Abstract:ABSTRACTA series of hydroxy‐terminated polyether‐polydimethylsiloxane‐polyether (α,ω‐dihydroxy‐(PE‐PDMS‐PE)) ABA triblock oligomers were synthesized from silanic fluids and methyl polyallyloxide polyethers. The reaction was a one‐step solventless hydrosilylation reaction with chloroplatinic acid (CPA) catalyst in the presence of heat. These ABA oligomers were characterized via 1H‐NMR, 13C‐NMR, 29Si‐NMR, FT‐IR, and GPC to demonstrate that they exhibit a 100% linear ABA structure with a siloxane SiO chain in the center and polyether ethylene oxide (EO)/propylene oxide (PO) chains on the two sides terminated by hydroxy groups. The triblock oligomers were used to form thermoplastic polyurethanes (TPUs) using two‐step solventless bulk polymerization. The investigation of triblock oligomers impact on TPUs mechanical properties, thermal performance, surface water repellency, and morphology performance were analyzed by Instron material tester, differential scanning calorimetry (DSC), thermogravimetric analysis (TGA), water contact angles (WCA), scanning electron microscope (SEM), and transmission electron microscope (TEM). DSC and TGA indicated that PE‐PDMS‐PE modified TPUs had a clear lower Tg under −120°C and the temperature of 50% weight loss was improved from 280 to 340°C. PE‐PDMS‐PE–modified TPU did not have the marked reduction on mechanical properties than pure polyether produced TPU. Tensile strength was maintained at 13 MPa and elongation was maintained at 300%. SEM and TEM were used to investigate the copolymers’ morphology performance and found that all PO PE‐PDMS‐PE had a pseudo‐three phase separation. WCA analysis confirmed that PE‐PDMS‐PE–modified TPU had significantly improved hydrophobic performance because the silicone structure linked into TPU copolymers. © 2015 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2015, 132, 42521.

Well-Defined Pe-B-Pdms Diblock Copolymers Via The Combination Of Thiol-Ene Click And Esterification Reactions: Facile Synthesis And Compatibilization For Hdpe/Silicone Oil Blends

Novel Polyethylene‐b‐polyurethane‐b‐polyethylene Triblock Copolymers: Facile Synthesis and Application

Synthesis, characterization and lubricating effect of long chain branched polydimethylsiloxane-g-polyethylene copolymers

Synthesis of Polyethylene-G-polydimethylsiloxane Graft Copolymers by Copolymerization of Ethylene with Polydimethylsiloxane Macromonomer

Poly(L-Lactide) Materials with Balanced Mechanical Properties Prepared by Blending with Peg-Mb-Ppa Multiblock Copolymers

Compatibilizing Efficiency of Copolymer Precursors for Immiscible Polymer Blends

Design of Well-Defined Polyethylene-g-poly-methyltrifluorosiloxane Graft Copolymers Via Direct Copolymerization of Ethylene with Polyfluorosiloxane Macromonomers

Polyethylene-B-Poly(Ethylene Glycol) Diblock Copolymers: New Synthetic Strategy and Application

Synthesis and Solution Properties of Pdms-B-Peo Amphiphilic Diblock Copolymers

Polystyrene/High Density Polyethylene Blends Compatibilized by a Tri-Block Copolymer I. Properties and Morphology

Compatibilizing Effect of Polystyrene-Block-Poly(4-Vinylpyridine) for Poly(2,6-Dimethyl-1,4-Phenyleneoxide) Chlorinated Polyethylene Blends

Polyethylene‐poly(L‐lactide) Diblock Copolymers: Synthesis and Compatibilization of Poly(l‐lactide)/polyethylene Blends

Studies On High Density Polyethylene/Polycarbonate Blend System Compatibilized With Low Density Polyethylene Grafted Diallyl Bisphenol A Ether

Insight on Compatibilization of LLDPE/PS Blends from Morphology, Interfacial State, Mechanical Properties and Melt Properties: Comb-like Copolymer Vs Diblock Copolymer

Synthesis and Characterization of Amphiphilic PMTFPS‐b‐PEO Diblock Copolymers

Effect And Mechanism In Compatibilization Of Poly(Styrene-B-2-Ethyl-2-Oxazoline) Diblock Copolymer In Poly(2,6-Dimethyl-1,4-Phenylene Oxide) Poly(Ethylene-Ran-Acrylic Acid) Blends

Synthesis and Characterization of Hydroxy‐terminated Polyether‐polydimethylsiloxane‐polyether (PE‐PDMS‐PE) Triblock Oligomers and Their Use in the Preparation of Thermoplastic Polyurethanes

Synthesis of Poly[methyl(3,3,3-Trifluoropropyl)siloxane]- B -Poly(ethylene Oxide) Block Copolymers

Morphology and compatibility of compatibilized polyethersulfone and polycarbonate blends

Influences of Dicumyl Peroxide on Morphology and Mechanical Properties of Polypropylene/poly(styrene‐b‐butadiene‐b‐styrene) Blends Via Vane‐extruder

Effect of Compatibilizer Content on the Tensile Properties and Fracture Toughness of High Density Polyethylene/Polystyrene Blends